Viking F21311 EN manual Troubleshooting Guide, Other Maintenance Check the top bearing

Care and Cleaning (con’t)

After 40 minutes the ice machine and all the control panel lights will shut off.

13.Pull the drain plug again to drain the system, then replace it.

14.Return the reservoir cover to its original position.

15.Return the upper back wall of the bin to its original position and secure it with the original screws. Push in to snap it into place.

16.Pour a gallon of hot (95oF. – 115oF.) water into the bin to flush out the drain and melt all ice that was made during the cleaning process. Be sure all ice is melted.

17.Clean the bin liner of mineral scale by using any left over scale remover solution to scrub the scale off of the liner. If none is left over, mix a solution of 2.5 ounces of Clear 1 Scale Remover and 1 quart of water.

18.Rinse the liner with hot water.

19.Sanitize the bin interior.

20.Push and release the On/Off button to restart ice making.

The ice scoop should be washed regularly, wash it just like any other food container.

Other Maintenance

Note: It is normal for some lime scale to form on the gear reducer cover. Wipe up any loose scale.

Check the top bearing.

The top bearing is non-metallic and requires no lubrication. However, it should be checked for wear occasionally. The top panel must be removed to access the bearing. The wear limit is 1/64”, and can be checked with a pin gauge.

Troubleshooting Guide

PROBLEM	CORRECTION
Low capacity	• Check for restricted drain or standing
	water in the bin.
	• Clean the air cooled condenser fins.
	• Clean the ice machine system.
No ice	• Check On/Off switch.
	• Check electrical breaker.
	• If the “Check Water” light is flashing
	blue, check water supply. The control
	system checks for water every 20
	minutes. When the water supply is
	restored, the machine will
	automatically restart ice making.
“Time to Clean” light is on	• Clean the ice making system

14 15