Viking D3 manual Surface Operation, Lighting Burners, Surface Cooking Tips, Surface Heat Settings

Operation

Surface Operation

Lighting Burners

All burners are ignited by electric ignition. There are no open-flame, “standing”pilots.

Surface Burners-AutomaticRe-ignitionTo light the surface burners, push and turn the appropriate control knob counter clockwise to any

position. This control is both a gas valve and an electric switch. Burners will ignite at any “ON” position with the automatic re-ignition system. If the flame goes out for any reason, the burners will automatically reignite if the gas is still flowing. When gas is permitted to flow to the burners, the electric igniters start sparking. On all surface igniters you should hear a “clicking” sound. If you do not, turn off the control and check that the unit is plugged in and that the fuse or circuit breaker is not blown or tripped.

Within a few moments, enough gas will have traveled to the burner to light. When the burner lights, turn the burner control to any position to adjust the flame size. Setting the proper flame height for the desired cooking process and selecting the correct cooking vessel will result in superior cooking performance, while also saving time and energy.

Surface Cooking Tips

Your range is equipped with a variety of different sized surface burners. Below is a guide for which burners work best for certain cooking applications:

Burner	Use
Front left dual stacked	A versatile burner which is good for both
18,000 BTU burner	bringing large quantities of liquid to
	temperature or for simmering larger amounts
	of sauces, etc.
Rear left 8,000 BTU burner	Best for simmering delicate sauces, etc.
Center 9,000 BTU burner	Best for use with the reversible griddle/grill
	accessory
Front right 17,000 BTU burner	Best for bringing large quantities of liquid to
	temperature and when preparing large
	quantities of food
Rear Right 12,000 BTU burner	Best used for most standard surface cooking
	needs

Surface Operation

Surface Cooking Tips (cont.)

•Use low or medium flame heights when cooking in vessels that are poor conductors of heat, such as glass, ceramic, and cast-iron. Reduce the flame height until it covers approximately 1/3 of the cooking vessel diameter. This will ensure more even heating within the cooking vessel and reduce the likelihood of burning or scorching the food.

•Reduce the flame if it is extending beyond the bottom of the cooking vessel. A flame that extends along the sides of the vessel is potentially dangerous, heats the utensil handle and kitchen instead of the food, and wastes energy.

•Reduce the flame height to the minimum level necessary to perform the desired cooking process. Remember that food cooks just as quickly at a gentle boil as it does at a rolling boil. Maintaining a higher boil than is necessary wastes energy, cooks away moisture, and causes a loss in food flavor and nutrient level.

•The minimum pot or pan (vessel) diameter recommended is 6” (15 cm) on the larger burners. Pots or pans as small as 4” (10 cm) should be used on the smaller burners.

Surface Heat Settings*

Heat Setting	Use
Simmer	Melting small quantities
	Steaming rice
	Simmering sauces
		Operation
Low	Heating milk, cream sauces, gravies,
	Melting large quantities
Med Low	Low-temperature frying (eggs, etc.)
	Simmering large quantities
	and puddings
Med	Sauteing and browning, braising, and
	pan-frying
	Maintaining slow boil on large quantities
Med High	High-temperature frying
	Pan broiling
	Maintaining fast boil on large quantities
High	Boiling water quickly
	Deep-fat frying in large utensil

*Note: The above information is given as a guide only. You may need to vary the heat settings to suit your personal requirements.

18 19