IMPORTANT
SAFEGUARDS
When using your Compact Sparkling Beverage Maker – Powered by SodaSparkle™, basic safety precautions should always be followed, including the following:
Use only Cuisinart
1.Read instructions thoroughly before use.
2.Always properly disassemble the unit when not in use, before putting on or removing parts and before cleaning.
3.Please supervise closely when in use near children. Do not let children operate beverage maker.
4.If the Compact Sparkling Beverage Maker has any damage or malfunctions, DO NOT OPERATE. Contact our Customer Service Center to return for an examination, repair or adjustment. Use only Cuisinart
5.Using accessory attachments not sold or recommended by Cuisinart can cause the unit to malfunction or cause injury.
6.Do not allow the unit or its contents to come into contact with any hot surfaces, including stove, or to hang over table edge or counter. Do not store in a vehicle.
7.Before operating, always make sure the Compact Sparkling Beverage Maker is properly positioned and securely in place. Use only as intended while the unit is in operation.
8.After each use, be sure the unit is no longer under pressure before disassembling.
9.Do not put finger or other objects into the Sparkling Beverage Maker while it is in operation.
10.Do not use the appliance for anything other than the intended purpose, as outlined in the instruction booklet.
11.Operate the unit only when the bottle is filled with chilled water to the indicated fill line.
12.Do not attempt to carbonate when bottle is empty.
13.Never overfill the bottle.
14.Do not under any circumstances try to carbonate hot water, as the bottle may burst.
15.Do not use excessive force while handling or operating the unit, as this can damage components.
16.Any flavors or fruit juice must be added after carbonation. Remember to thoroughly clean and rinse the bottle after use if any flavors, syrups or juices are added to the bottle after carbonation.
17.Ensure that the carbonator head is screwed straight down onto the bottle to avoid
18.When operating the system, always ensure the charger chamber is screwed down straight on the carbonator head to avoid cross- threading and do not use the product if the charger chamber is not straight on the carbonator head.
19.Ensure that the bottle is on a flat surface when operating the system. Do not lean over the bottle while screwing down the carbonator head.
20.Remove the charger chamber and carbonator head only after the CO2 charger has completely finished discharging. You should wait at least 30 seconds before attempting to remove.
21.Do not invert the charger chamber or carbonator head unless fully
2