JVC KDX210 ~~/~, ~~~, A Warning, Installing the unit in-dashmounting, A Caution, sleeve

z	A Warning
0	•	The unit can only be used with a12 VDC power supply, negative'ground.
-	•	Disconnect the battery'snegative terminal before wiring'and mounting.
....	•	Do not connect Battery wire (yellow) and Ignition wire (red) to the car
u
		chassis or Ground wire (black) to prevent ashort circuit
w
	•	Insulate unconnected wires with vinyl tape to prevent ashort circuit.
z
	•	Be sure to ground this unit to the car'schassis again after i~stallation.
z

Installing the unit (in-dash mounting) 1

Do the requi.red wiring.

·o	A Caution
u	•	For safety'ssake, leave wiring and mounting to professionals. Consult the
		car audio dealer.
..........
z	•	Install this unit in the console of your vehicle. Do not touch the metal
		parts .of this unit during and shortly after use of the unit. Metal parts such
0
		as the heat sink and enclosure become hot.
-
	•	Do not connect the 8 wires of speakers to the car chassis or Ground wire
....
cc		(black), or connect them in parallel.
....

2

Hoo~ on the top side
	\
Orientate the trim plate as	/~~~; ~... \
illustrated before fitting.	\,,)
	'..... -,r"

			(+17)			.
!dt~f~;~l~ .								~
:~;,··.···'..., .....1					~~/~
"".. ....~.·--.·.·..								(D)
·.	,.-.:f~						,	.
'	~--,,:\ a			r:<~..............~			..,"'
	·•'••V		.		,	........1
......	.'/
	'~~.)."..,...""''\\						Dashboard of
	.,,~		......	""~
	,,	,				(C)	your car

I

....	~	Connect speakers with amaximum power of more than 50 W.lf the
		maxim_um power of the speakers is lower than 50 W, change the
cc
		[AMP GAIN]'setting to avoid damaging the speakers. (+11)
....
	•	Mount the unit at an angle of less than 30°.
z
	•	If your vehicle wiring harness does not have the ignition terminal,
"' connect Ignition wire (red) to the terminal on the vehicle'sfuse box
-		which provides 12 VDC power supply and is turned on and off by the

~~B) ~A)

~ Bend the appropriate tabs to hold the sleeve firmly in place.

	ignition key.
•	After the unit is installed, check whether the brake lamps, blinkers,
	wipers, etc. on the car are working properly.
•	If the fuse blows, first make sure the wires are not touching car'schassis,
	then replace the old fuse with one that hasthe same rating.

When installing without the mounting II	How to remove the unit
sleeve
A Use only the specifi.ed screws; Using wrong screws
might damage the unit.

Basic procedure
1	Remove the key from the ignition switch, then
	disconnect the 8 terminal of the car battery.
2	Connect the wire$ properly.
	See Wiring connection. (+17)
3	·Install the unit to your car.	..

'Flat or round head screws (not suppHed)

M5 X 8 mm (M5 X 3/8")

\'~~~

...........

8 mm (3/8")

i1 .(]

8 mm (3/8") - ~ ~~

	See Installing the unit (in-dash mounting).
4	Connect the 8 terminal ofthe car battery. ·
S	Reset the unit.(+ 3)

""l ~~~

~B:cket (not supplied)

16