KitchenAid MICROWAVE HOOD manual Display, Clock, Tones

Display

The display screen shows the time of day and Home screen when the microwave oven is not in use. During programming, it displays function menus, servings and weights, preparation instructions, and cooking time/power settings. During a cooking cycle, it counts down the remaining time, and gives prompts to stir or turn food.

The following illustrates how the MICRO-DIAL™ control and display screens help the navigation through menus. This example shows the display screens and selections when cooking regular quick oatmeal.

1.Touch FIRST SCREEN pad. Press dial to select Cook.

2.Turn dial to Cereals. Press dial to select.

3.Turn dial to Regular Quick Oatmeal. Press dial to select.

4.Turn dial to 3 servings. Press dial to select.

5.Turn dial to Start. Press dial to select. (For preparation instructions, select Prepare and follow the instructions.)

6.Wait for tones that signal end of cooking time.

Clock

This is a 12 hour clock, showing a.m. and p.m. When power is first supplied to the microwave oven, or after a power failure, the “Welcome” screen will appear.

To Set Clock:

1.Touch FIRST SCREEN pad.

2.Turn dial to Custom. Press.

3.Turn dial to Set Clock. Press.

4.Turn dial to set hours. Press.

5.Turn dial to set minutes. Press.

6.Turn dial to AM or PM. Press.

7.Press dial again to complete the Clock settings.

The Clock display may be turned off. While off, the Clock continues to keep the correct time.

To Turn Clock On/Off: Touch FIRST SCREEN pad. Select Custom. Select Set Clock. Touch OFF/CANCEL. To restore Clock display, touch FIRST SCREEN pad. Select Custom. Select Set Clock. Press dial.

Tones

Tones are audible signals, indicating the following:

One tone

■MICRO-DIAL control programming tone

■End of Timer countdown (long tone)

Two tones

■Reminder, repeat each minute for 15 minutes after the end- of-cycle tones

Three Tones

■Invalid entry

Four tones

■End-of-cycle

All Tones

All of the preceding tones, as well as end-of-stage and turn or stir tones are preset on, but can be turned off.

To Turn Off Tones:

1. Touch FIRST SCREEN pad.

2. Turn dial to Custom. Press.

3. Turn dial to Signals. Press.

4. Turn dial to desired tone.

5. Press dial to turn off.

Repeat above steps to turn tones back on.

See “Learning Mode” section to see how to practice navigating through the menus without turning on the magnetron.

The display contrast may be adjusted to a desired contrast level.

To Set Display Contrast: Touch FIRST SCREEN pad. Turn dial to Custom. Press. Turn dial to Display Contrast. Press. Follow directions to set desired contrast.

8