KitchenAid KERS807SBB VerifyAnti-Tip Bracket Location, Level Range, Supply cable

Page 12

3.Loosen (do not remove) the hex washer head screw and insert the neutral (white) wire under the screw clamp at the bottom of the center position terminal connector.

4.Insert the other 2 wires (lines 1 and 2) under the other 2 screw clamps.

B

A

A.Insert wire under screw clamp.

B.Hex washer head screw

5.Securely tighten the hex washer head screws to

35 lbs-in. (4.0 N-m) minimum torque to make proper electrical connection.

6.Tighten the locking ring of the conduit connector.

7.Replace the terminal block cover with screw.

3-wire connection: Direct Wire

Use this method only if local codes permit connecting ground conductor to neutral supply wire.

1.Loosen (do not remove) the hex washer head screws and insert the neutral (white) wire under the screw clamp at the bottom of the center position terminal connector.

 

D

C

 

 

E

 

F

B

G

 

A

 

A. Line 1

E. Neutral (white) wire

B. Ground-link

F. Line 2

C. Hex washer head screw

G. UL listed conduit

D. Silver-colored terminal

connector and power

block screw

supply cable

2.Insert the other 2 wires (lines 1 and 2) under the other 2 screw clamps.

B

A

A.Insert wire under screw clamp.

B.Hex washer head screw

3.Securely tighten the hex washer head screws to

35 lbs-in. (4.0 N-m) minimum torque to make a proper electrical connection.

4.Tighten the locking ring of the conduit connector.

5.Replace the terminal block cover with screw.

VerifyAnti-Tip Bracket Location

IMPORTANT:

■On models with a warming drawer, the rear range foot must be viewed from the front and slightly to one side of the range.

■On models with a storage drawer the drawer may be removed to better view the rear range foot.

1.To remove storage drawer:

■Pull drawer straight out to the first stop.

■Lift up the back of the drawer and pull out.

2.Making sure the anti-tip bracket is installed:

■Look for the anti-tip bracket securely attached to floor.

■Slide range back so rear range foot is under anti-tip bracket.

3.If installing the range in a mobile home, you must secure the range to the floor. Any method of securing the range is adequate as long as it conforms to the standards in the “Location Requirements” section.

Level Range

1.Place rack in oven. Place level on rack and check levelness of range, first side to side; then front to back.

If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket.

Use pliers or wrench to adjust leveling legs up or down until range is level. Push range back into position. Check that rear leveling leg is engaged in anti-tip bracket.

NOTE: Range must be level for satisfactory baking conditions.

2.Replace the storage drawer:

■Fit the ends of the drawer rails into the guides in the cavity.

■Slide the drawer closed.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents W10118260A Range Safety Table DES MatièresInstallation Requirements Toolsand PartsLocation Requirements Mobile Home Additional Installation Requirements Product Dimensions Freestanding RangeMobile home installations require Slide-in RangeCabinet Dimensions Electrical Requirements U.S.A. OnlyElectrical Connection If connecting to a 4-wire system If connecting to a 3-wire systemWire receptacle 14-50R Wire receptacle 10-50RInstallation Instructions Countertop PreparationUnpack Range Measure for Proper HeightAdjust LevelingLegs Install Anti-Tip BracketFreestanding Ranges Power Supply Cord Direct WireStyle 1 Power supply cord strain relief Electrical Connection U.S.A. OnlyWire connection Power Supply Cord Style 2 Direct wire strain reliefRemovable retaining nut Strain relief Black horizontal cross brace Flexible conduitDirect Wire Installation Copper or Aluminum Wire Wire Connection Direct WireInsert wire under screw clamp Hex washer head screw VerifyAnti-Tip Bracket LocationLevel Range Supply cableComplete Installation For power supply cord-connected rangesFor direct-wired ranges Moving the RangeExigences Dinstallation Sécurité DE LA CuisinièreOutillage et pièces Outillage nécessaireExigences demplacement Pièces nécessairesPlanchette de remplissage arrière facultative Lors de l’utilisation d’un cordon d’alimentation électriqueDimensions du produit Cuisinière autoportante Cuisinière coulissante³⁄₄ 14,6 cm B 76,2 cm Dimensions du placard Largeur de louverture 30 76,2 cm minSpécificationsde l’installation électrique Préparation du plan de travailInstructions Dinstallation Déballage de la cuisinièreMesurespour une hauteur appropriée Cuisinières coulissantesInstallation de la bride antibasculement Ajusterles piedsde nivellementVérification de lemplacement de la bride Antibasculement Acheverl’installationRéglage de laplomb de la cuisinière Déplacement de la cuisinière Cuisinières alimentées par cordon dalimentationPour les cuisinières avec câblage direct Si la cuisinière ne fonctionne pas, contrôler ce qui suitHoles in bracket Trous dans la bride W10118260A All rights reserved

KERS807SBB specifications

The KitchenAid KERS807SBB is a standout in the realm of kitchen appliances, renowned for its versatile cooking capabilities and stylish design. This range combines technology, efficiency, and aesthetic appeal, making it an ideal addition to any modern kitchen.

One of the key features of the KERS807SBB is its large capacity oven, which offers a generous 6.4 cubic feet of cooking space. This ample size allows home cooks to prepare multiple dishes simultaneously, ideal for family gatherings or dinner parties. The oven is equipped with a True Convection cooking system, which employs a third heating element and a powerful fan that circulates hot air throughout the oven. This technology ensures even baking and roasting, eliminating hot spots and ensuring that every dish is cooked to perfection.

The range boasts a sleek stainless steel finish, which not only enhances its durability but also adds a touch of elegance to any kitchen decor. Its glass touch controls make adjusting settings and selecting cooking modes intuitive and user-friendly. The oven also features an adaptive bake function that adjusts cooking time and temperature for various dishes, enhancing cooking precision.

In addition to its impressive oven capabilities, the KERS807SBB offers a powerful cooktop with five burners, including a high-output burner that provides intense heat for quick boiling or searing. The burners include a simmer setting, perfect for delicate sauces or melting chocolate. All burners are designed for easy cleanup, featuring sealed designs to prevent spills from reaching the burner compartment.

The range also includes a self-cleaning feature that simplifies maintenance and upkeep, saving time and effort for busy home cooks. Its Warm Hold feature ensures that food remains at the perfect temperature until serving, providing peace of mind during meal preparation.

In terms of energy efficiency, the KERS807SBB is designed to minimize energy consumption while delivering high performance. It’s a perfect blend of modern technology and classic design, making it a practical and stylish choice for anyone looking to elevate their culinary experience.

With its premium features and user-friendly technologies, the KitchenAid KERS807SBB is more than just a cooking appliance; it's an essential tool for any home chef seeking reliability, efficiency, and sophistication in the kitchen.
Top Page Image Contents