Operating the Remote Control System Setup

OPERATING THE REMOTE CONTROL

SYSTEM SETUP

Battery Installation

1. Push down and out on the battery Compart- ment cover to remove it.

2. Insert the two "AAA" batteries into the battery compartment of the remote control, making sure the + and - signs on the batteries and inside the battery compartment match up.

3. Replace the battery compartment cover.

Notes:

Do not mix batteries from different manu- facturers, nor old ones with new.

If the remote control will not be used for an extended period of time, remove the batteries to prevent damage-causing corrosion.

Remove dead batteries immediately to prevent damage-causing corrosion.

If battery leakage occurs, wipe the battery liquid from the battery compartment, then replace both batteries.

Always replace both batteries at the same time, using new, fully charged batteries.

Life expectancy of batteries may vary depending on amount of use.

Using the Remote Control

Point the remote control at the remote sensor on the DVD receiver. When the signal is received from the remote control, the unit will function accordingly. The remote will operate to approximately 16' from the remote sensor at an angle of around 30 each direction.

Notes:

Do not direct the remote sensor toward any light source, such as direct sunlight or a strong fluorescent light, as it may cause the unit to not operate correctly.

When other remote controls are used nearby or when the remote is used near

equipment using infrared rays, interference

may occur.

Placing an object on the remote control

may cause it to inadvertently depress a

button, changing a function and shortening

battery life.

Do not glaze the front of the DVD receiver with colored glass, as it may cause interference with normal operation of the controller.

Make sure there is no barrier between the remote control and remote sensor, as it could prevent the unit from receiving the signal.

Do not spill water or put wet items on the remote control.

Never disassemble remote control.

BATTERIES

INCORRECT USE OF BATTERIES MAY CAUSE THEM TO LEAK, CORRODE OR EXP LODE.

Video Setup

Select [Video] in the Setup Menu, and press ENTER to display the [Video] submenu:

Press to select the menu item

A.Press ENTER orto set

B.Press to return to the Setup Menu

Select [TV shape], and press ENTER or to display the [TV shape] submenu:

Press to change your selection

A. Press ENTER to confirm B. Press SETUP to exit the Setup Menu

[4:3 PS] -Pan and scan refers to pictures where part of pictures is cut

off so it fills the whole screen.

[4:3LB] -Letter Box refers to pictures where black bands appear at the

top and bottom.

[16:9] -The picture fills the screen of a wide-screen (16:9) television.

Note: Not all DVDs offer movies in Full Screen format. If not, the disc will override your

TV Display setting and the movie will be displayed in Letterbox format.

Select [TV system] and press ENTER or to display the [TV system] submenu:

Press to change your selection

A. Press ENTER to confirm

B. Press SETUP to exit the Setup Menu.

[NTSC] -Select if you are using NTSC signal system to match your TV set. [PAL] -Select if you are using PAL signal system to match your TV set. [AUTO]- Select if you are using AUTO signal system to match your TV set.

HOW IT WORKS 8

21 HOW IT WORKS