4Clean the coffee spout, the pod holders and the drip tray in hot water, if necessary with some
5Hold the cup tray in your hand while you clean it with hot water, if necessary with some
You can also clean the cup tray in the dishwasher.
To clean the cup tray, always remove it from the machine, as it might prove sharp when it is handled incorrectly.Always handle it carefully.
6Clean the pod holders in hot water, if necessary with some
Make sure the sieve in the centre of the pod holder is not
clogged. If the sieve is clogged, unclog it by rinsing the pod holder under a running tap. If necessary, use a
7Clean the water reservoir in hot water, if necessary with some
Note:You can remove the cover of the water reservoir to clean the inside thoroughly.
Note: If you use a
8Rinse the parts with fresh water after cleaning and put them back into the machine.
9Clean the water distribution disc with a moist cloth (Fig. 25).
Be careful when you do this. Make sure that the rubber
sealing ring does not get stuck under the edge of the water distribution disc. If it does, the coffee machine starts to leak!
Flushing
If you have not used the coffee machine for three days,
flush it with fresh water before you use it again.
Flush the machine in the following way:
1Fill the water reservoir with cold water up to
the MAX indication and put it back onto the machine. (Fig. 3)
2Put the
3Put a bowl (with a capacity of at least 1500ml) under the coffee spout to collect the water. (Fig. 8)
4Press the on/off button I and subsequently press the
The machine fills itself with water from the water reservoir.This takes some time and you will probably not
notice that this happens. After a while, the machine starts
to flush and switches itself off after the flushing cycle.
Descaling
Regular descaling prolongs the life of the coffee machine and guarantees optimal brewing results for a long time. If you use the machine twice a day on average, you must descale it once every 3 months.
1Fill the water reservoir up to the MAX indication with descaler and water according to the instructions on the package of the descaler.Then put the water reservoir back onto the coffee machine. (Fig. 3)
Use a descaler based on citric acid.
2Press on/off button I. (Fig. 10)
The machine is ready for use when the indicator light
burns continuously.
3Place the
We advise you to put a used coffee pod in the pod
holder when you descale the machine.This pod serves as a ‘filter’ to prevent the sieve in the pod holder from
getting clogged with scale residues.
4Put a bowl with a capacity of at least 1500ml under the coffee spout to collect the mixture of descaler and water. (Fig. 8)
5Press the
Never descale the SENSEO\ coffee machine with the lid open. Make sure the lid is properly locked.
6Repeat steps 1 to 5 with a new mixture of descaler and water.
7Rinse the water reservoir with fresh water to remove descaler residues.
Flush the machine with fresh water at least 3 times by repeating steps 1 to 5.
,Do not refill the water reservoir with used hot water.
8Clean the pod holder after descaling to prevent the sieve in the centre from getting clogged.
Frost-free storage
If the coffee machine has already been used and
therefore has been flushed with water, it may only be
used and stored in a
Replacement
You can order all removable parts from your Philips dealer or a Philips service centre.
Environment
,Do not throw away the machine with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment (Fig. 27).
Guarantee & service
If you need service or information or if you have a
problem, please consult the worldwide guarantee leaflet or visit our website at www.philips.com.You can also
contact the Philips Customer Care Centre in your country; they will be happy to help you.
The telephone number fior the United Kingdom is: 0845- 6010354.
You find the telephone numbers for other countries in the worldwide guarantee leaflet. If there is no Customer Care
Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic
Appliances and Personal Care BV.You find their address and fax number in the worldwide guarantee leaflet. The purchase of the Philips SENSEO\ coffee machine
does not exhaust any of the rights of Sara Lee/Douwe Egberts or Philips under any of their patents nor does it confer upon the purchaser a licence under these patents.
Troubleshooting
If you have a problem, you may find the solution in the
table below. If the table does not provide the solution to your problem or if you have a question, see the chapter ‘Guarantee & service’.
Problem | Solution |
|
|
The indicator | You have not yet flushed the coffee | ||
light continues | machine (see chapter ‘Preparing the | ||
to blink slowly. | machine for use’. |
|
|
| You have used the SENSEO | coffee | |
| machine at an altitude | higher than | |
|
| \ | |
| 2200 metres above sea level.This | ||
| has caused the water in the machine | ||
| to start boiling before it has |
| |
| reached the required temperature. | ||
| This prevents the machine from | ||
| functioning properly. Switch off the | ||
| machine and no longer use it at | ||
| altitudes higher than 2200 metres | ||
| above sea level. |
|
|
The SENSEO | You have not yet flushed the coffee | ||
coffee machine\ | machine.When you use the machine | ||
does not | for the first time, you have to flush it | ||
produce coffee | before you can start brewing coffee | ||
when it is | (see chapter ‘Preparing the machine | ||
switched on for | for use’). |
|
|
the first time. |
|
|
|
The indicator | Make sure that: |
|
|
light continues |
|
|
|
to blink rapidly. |
|
|
|
Problem | Solution |
| you have placed the water |
| reservoir properly; |
| there is enough water in the water |
| reservoir (i.e. above the ° MIN |
| level if you want to brew 1 cup); |
| the ambient temperature is not |
| lower than 10°C. If it is, the machine |
| does not function properly. |
Water leaks | Make sure that: |
from the coffee |
|
machine. |
|
| you have closed the lid properly |
| (the lever must be properly locked); |
| you have not filled the water |
| reservoir beyond the MAX level; |
| the sieve in the centre of the pod |
| holder is not clogged. If the sieve |
| is clogged, unclog it by rinsing the |
| pod holder under a running tap. If |
| necessary, use a |
| or a pin to unclog the sieve; |
| you have put the coffee |
| pod properly in the centre of the |
| pod holder; |
| the sealing ring is not stuck under |
| the edge of the water distribution |
| disc; |
| the water drops on the worktop are |
| not the result of placing or removing |
| the water reservoir or removing used |
| coffee pods; |
| you do not remove the water |
| reservoir when the coffee machine |
| is heating up.This may cause water |
| that normally ends up in the water |
| reservoir to leak out of the machine. |
| In all other cases, contact the Philips |
| Customer Care Centre in your |
| country. |
The lid cannot | A vacuum may have temporarily |
be opened. | formed under the lid. |
| Switch off the machine. Pull the |
| lever up as far as it goes and wait 24 |
| hours before you open the lid.You |
| may need to use quite some force. |
| Make sure that the sieve in |
| the centre of the pod holder |
| is not clogged. If the sieve is |
| clogged, unclog it by rinsing the |
| pod holder under a running tap. If |
| necessary, use a |
| or a pin to unclog the sieve. |
| If problems continue to occur, |
| contact the Philips Customer Care |
| Centre in your country. |
The coffee | Perhaps the sieve in the centre of |
machine | the pod holder is clogged. If the |
produces less | sieve is clogged, unclog it by rinsing |
coffee than | the pod holder under a running tap. |
before. | If necessary, use a |
| or a pin to unclog the sieve. |
| Descale the machine (see chapter |
| ‘Descaling’). |
4222.001.9719.8 | 3/4 |