Floor Damage
Slide dishwasher onto cardboard or hardboard before moving across floor. Failure to do so may cause damage to floor coverimzf.
Place drain hose on the left side of the cabinet opening between the motor and the frame. -
Latch dishwasher door. Grasp dishwasher by the door frame and push the dishwasher into the cabinet opening. Be careful not to push on the dishwasher panels. Center dishwasher in cabinet opening. Check that front leveling legs are firmly against the floor.
Connect 318” NPT
compression elbow (3/8” NPT one end). Connect street elbow to water valve. Connect supply line to compression elbow. If galvanized pipe is used, use a second 3/8” street elbow in place of the compression eydz
Disconnect brackets located at the toD corners
of flange. Reattach brackets with bracket end facing away from dishwasher. Drill starter holes 3/4” deep through bracket holes into the underside of countertop using a l/8” drill bit. Do not exeed 3/4” depth. Attach brackets to underside of countertop. Make sure the screw
| back of | dishwasher | h |
|
|
|
|
n |
|
|
| leek | that | drain | |
alternate | position | hose | hose is | not | kinked | ||
|
| crimDed | or | contactina |
heads do not interfere with the door.
You MUST secure dishwasher to keep it from tilting when door is opened or closed. Do Not drop screws In dishwasher tub. If screws should fall Into the pump, pump and motor failure may
rear cross channel original posltlon
Check to see if rear cross channel contacts
drain, electrical or water lines. If the channel contacts any line, pull dishwasher out of opening. Do Not remove the channel. Remove both cross channel screws on the
Align dishwasher door
with cabinet front, not doors.
Page 6
Remove red plug from dishwasher valve. (A small amount of water may still be in the valve area from quality assurance testing.) Place hose clamp over dishwasher valve. Connect drain hose to valve and secure with hose clamp. Check for good fit and that there are no bends or kinks in drain hose that could restrict water flow.
top mounting
Open dishwasher and
pieces for upper corners of door.- Remove bottom rack. Place a newspaper or large sheet of paper over bottom of dishwasher to protect the pump area when securing dishwasher to countertop.
occur. Remove paper from bottom of dishwasher.
If brackets cannot be attached to countertop, Do Not disconnect brackets. Attach dishwasher to floor using 1/4”lag bolts through hole in each side of dishwasher frame.
equally spaced
/\
Open door approximately 3” and check for equal
spacing between inner door and tub sides. If necessary, loosen screws that fasten dishwasher to countertop and shift tub. Retighten screws.