Custom-made panels
9116" |
*For Models: KUDA220T and
Custom wood or other materials should be l/4” thick. Thinner materials will need to have a spacer panel installed behind custom panel. If custom panel is more than i/4” thick, the outer edge
will need to be routed as shown. Custom wood panels need a waterproof protective finish applied to all sides and edges of panel.
If the dishwasher is not operating properly.. .
Check these points:
l Is the door closed tightly and latched securely?
9 Has the cycle been set correctly to start the dishwasher?
l Is the water turned on?
l Has a house fuse blown?
l Has electrical power been interrupted?
Note: If the motor has stopped because of overload, it will automatically reset itself within a few minutes.
If after checking these points the dishwasher still does not run or complete a cycle, call for service.
After custom panels are installed, check the door tension. The door should be counterbalanced so it doesn’t fall open or close when opened. If the door closes from an open position, adjust the
Part No. 4171206 | Prepared by KitchenAid@,St. Joseph, Michigan 49085 | Printed in U.S.A. |
01989 KitchenAid |
|
|