Maintenance, Cleaning the hood | Hotpoint HS 110 specification

Maintenance

!Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance.

!To avoid possible risks of fire always comply with the indicated instructions when cleaning grease filters and when removing grease deposits from the appliance.

Careful maintenance will assure good functioning and good efficiency over time.

Cleaning the hood

Any fat deposits should be removed from the appliance periodically depending on amount of use (at least every 2 months). Avoid using abrasive or corrosive products. To clean painted appliances on the outside, use a cloth dipped in lukewarm water and neutral detergent. To clean steel, copper or brass appliances on the outside, it is always best to use specific products, following the instructions on the products themselves. To clean the inside of the appliance, use a cloth (or brush) dipped in denatured ethyl alcohol.

Cleaning the grease filters

To remove the grease filters, push the catch near the handle towards the inside and pull the filter downwards.

Wash the filters by hand or in the dishwasher using a neutral detergent. If they are washed

in the dishwasher, any loss of colour will

not jeopardise functioning of the filters in any way.

Clean the grease filters every 2 months on average depending on how heavily the hood is used.

Replacing the charcoal filter

If using the hood in the filtering version, the charcoal filter (P) will periodically have to be replaced.

First of all, remove the metal grease filters. Push the catch towards the inside and remove

the charcoal filter from its seat.

Replace the charcoal filter with one of the same type by carrying out the operations in reverse order.

Replace the charcoal filter on average every 6 months depending on how heavily the hood is used.

Replacing the lamps

Pay particular ATTENTION when carrying out

this operation and remember to remove the voltage. After having removed the grease filters, remove the light fitting, operating manually from inside

the hood.

Apply light pressure to the mobile part

of the 2 retainers and release it from the outside.

Unscrew the bulb and replace it with a bulb of the same type.

Re-assemble the light fitting by pushing it into its seat from the outside.