GB DOOR REVERSAL
Warning: Before attempting to remove the doors, switch off the electrical supply and pull out the mains plug.
It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated containers whilst carrying out this operation.
You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i.e. original packaging).
Remove the doors
1.Lay down the appliance on its back.
2.Unscrew, remove and retain the bottom hinge.
3.Slightly open the bottom door and slide downward remove and carefully place to one side
4.Remove centre hinge and spacer if fitted. Slightly open the top door and slide downwards, remove and carefully place to one side.
5.Unscrew and remove the top front cover from the cabinet .
6.Unscrew and remove the hinge pin and the bolt from the top right hand and refit them into the hole in the left hand side. Refit the top front cover.
7.Use a thin blunt instrument
to remove the top and bottom | 5 | 4 | |
hinge bushes and blanking | 3 | ||
plugs from the doors, take | |||
|
| ||
care not to mark the door |
|
| |
handle. Reposition the |
|
| |
blanking plugs and bushes |
|
| |
on the opposite side. |
| 2 | |
8. Fit the blanking plugs |
| ||
provided into the right hand |
| 1 | |
two centre hinge holes. |
|
6
7
Replacing the doors
8
1. | Slide the top door upwards and locate the top hinge pin into the door brush. Reposition the centre hinge on the | |
opposite side. |
| |
2. | Carefully slide bottom door upward | 1 |
into the centre hinge pin. | ||
3. | Unscrew the bottom hinge pin and | 2 |
refit it on the opposite side.. |
| |
4. | Fit the bottom hinge making sure that |
|
the door is aligned to the cabinet. |
| |
5. | Carefully stand the appliance upright | 3 |
in it’s required location and make sure it | ||
is sitting level on the floor. Open and close the doors checking that the gasket makes a good seal without any gaps when the doors are closed.
Note: Replace loose items/fittings back into the appliance and leave for at least 15 minutes before switching back on.
4