Electrical connection
Connect the appliance to an alternating current only, ranging from 220 V to
240 V and 50 Hz or 60 Hz via a correctly installed socket with protective earth conductor. See rating plate for required fusing 32 .
The socket must be near the appliance and freely accessible following installation.
The connection may be modified by technicians only.
A power cord extension may be purchased from customer service only. Use only a
The appliance features a water damage protection system. Please note the system will function only when the power supply is connected.
Removing the appliance
Also observe the sequence of worksteps here.
Disconnect the appliance from the power supply.
Turn off the water supply.
Disconnect the waste water and fresh water connections.
Loosen the fastening screws under the worktop.
If fitted, remove the base panel.
Pull out the appliance, carefully pulling the hose behind.
en
Transportation
Empty the dishwasher and secure loose parts.
Drain the appliance according to the following steps:
Turn on the tap. Open the door.
Switch on ON/OFF switch 1 . The displays of the last selected programme light up.
Select programme with the highest temperature.
The expected programme duration is indicated on the numerical display 3 .
Press START button 10 .
Close the door.
The programme starts running. Open door after approx. 4 minutes.
Press the START button 10 until on the digital display is indicated .
Close the door.
Open door after approx. 1 minutes. The numerical display indicates
.
Switch off appliance 1 and turn off the tap.
Transport appliance upright only. (This prevents residual water from running into the machine control and damaging the programme sequence).
Protection against frost
If the appliance is in a room where there is a risk of frost (e.g. holiday home), empty the appliance completely
(see Transportation).
Turn off the tap, disconnect supply hose and drain water.
25