Whirlpool RJH 3330-1 operating instructions YLrlmml

Page 1

READ AND SAVE THESE INSTRUCTIONS

YLrlmml

1 CORPORATION

INSTALLATION

AND

OPERATING

INSTRUCTIONS

FOR

MICROSHELF HOOD

MODEL RJH 3330-l

Before you begin, read the following instructions completely and carefully. If followed, they will simplify the installation job.

IMPORTANT: OBSERVE ALL GOVERNING CODES

AND ORDINANCES

SAVE THESE INSTRUCTIONS FOR THE LOCAL

ELECTRICAL INSPECTOR’S USE

BEFORE YOU USE YOUR MICROSHELF HOOD:

Be sure your Microshelf Hood is installed on an appropriate wall strong enough tosupport this appliance.

NOTE: The shelf of the Microshelf Hood is designed to support a Microwave Oven with a net weight of up to 75 pounds.

The area used for the installation must be suitable forthe size, function, and protection (from elements) of the Microshelf Hood.

CAUTION: When mounting the Microshelf Hood to a wall, you must locate 2 studs in the wall. Do not attempt to install the hood if the 2 wall studs are not found.

Be careful when drilling holes into a wall. Electrical wires and water pipes may be concealed behind the wall covering.

APPROVED FOR USE WITH WHIRLPOOL RJM AND RHM SERIES AND THE RFM 7300-l

MICROWAVE OVENS.

APPROVED FOR USE OVER WHIRLPOOL

CONVENTIONAL RANGE COOKTOPS THAT DO NOT HAVE A GRILLE.

Page

NOTE: The fan in the Microshelf Hood turns on automatically to protect the microwave oven when the temperature inside the hoodreaches 122°F (SO’C). It turns off automatically when the temperature falls below 95°F (35°C).

I. INSTALLATION REQUIREMENTS A. Space Requirements

A typical installation can be seen in Figure 1. Study Figure 1 before proceeding. The Microshelf Hood requires an opening that is 30” wide. It is recommended that the cabinet above the cooktop be a maximum of 15” high. This provides adequate space between the range cooktop and the Microshelf Hood.

 

 

 

l-

 

 

 

CEILING

--(

 

F

3;‘IO”.

 

FURR DOWN

APPROX

96”

%I

 

 

 

 

FROM

FLOOR

 

 

 

 

 

 

 

 

1

DUCT

 

 

 

 

%

TRANSITION

 

 

 

 

 

 

 

 

 

 

DUCT

 

FLOOR

T

 

 

PROVIDED

 

 

 

WITH

HOOD

 

t n000

MICROWAVE

 

 

 

 

II

 

OVEN

 

 

 

u

 

$

 

SHELF1

 

 

 

THICK

 

 

 

 

 

 

I5”MIN

 

 

SHEET

ROCK

 

COOK

TOP?

 

 

 

 

Figure 1

B. Electrical Requirements

A 120 Volt, 60 Hz, AC only, 20 Ampere fused electrical supply is required (time delay fuse or

circuit breaker is recommended). It is recommended that a separate circuit serving only this appliance be provided.

C. Venting Requirements

For vented installations, the venting system must terminate to the outside.

CAUTION: Do not terminate the vent in an attic or other enclosed space. This type of installation may result in a fire.

If a vertical venting system is used, using 3%” x 10” duct, the maximum length allowed is 25 feet. If elbows are used in the venting system, reduce the length of 3%” by 10” duct by 24 feet for each elbow used.

The Microshelf Hood may be centered horizontally as shown in Figure 2. The maximum length of duct run horizontally, using one 3%” x 10” elbow, is one foot

1

Image 1
Contents YLrlmml STUD, Consult a Local Building Contractor for Help II. Vented InstallationSCREW, NO. IO Thick Sheet RockHollow Wall Anchor Bolt Screw Removed from Installing and Leveling the Microwave OvenLifting ABILITY. WE Recommend Assistance Lights Care of FiltersCare of Exterior Surfaces ~irlpool

RJH 3330-1 specifications

The Whirlpool RJH 3330-1 is a sophisticated freestanding refrigerator that embodies modern design and advanced technology, making it a standout choice for contemporary kitchens. With a user-centric approach, this model ensures a perfect balance between functionality and aesthetics.

One of the main features of the Whirlpool RJH 3330-1 is its spacious interior. With a total capacity of approximately 336 liters, it provides ample space for storing groceries, beverages, and leftovers. The refrigerator compartment is designed with adjustable shelves, allowing users to customize storage according to their needs. The spacious freezer section also provides ample room for frozen goods, making meal planning and preparation efficient and convenient.

This refrigerator boasts several advanced technologies that enhance its performance. The No Frost system is a notable feature, which eliminates the need for manual defrosting. This technology prevents ice buildup, ensuring optimal airflow and temperature consistency throughout the refrigerator. As a result, food remains fresh for longer periods, ultimately reducing food waste.

Energy efficiency is another key characteristic of the Whirlpool RJH 3330-1. With an impressive energy rating, this model not only helps to lower electricity bills but also contributes positively to the environment. The use of LED lighting further enhances energy savings while providing bright and clear illumination of the interior.

In terms of design, the Whirlpool RJH 3330-1 features a sleek and modern exterior that blends seamlessly with various kitchen decors. The stainless steel finish offers durability and ease of cleaning, while the minimalist handles enhance the appliance's aesthetic appeal.

The cooling system is equipped with advanced temperature controls, allowing users to set optimal temperatures for different food types. This ensures that perishables remain at their best, extending the shelf life of fruits and vegetables.

In conclusion, the Whirlpool RJH 3330-1 combines practicality, efficiency, and style. Its spacious design, energy-saving technologies, and user-friendly features make it an excellent addition to any household. Whether you are a busy family or an individual who values convenience, this refrigerator offers solutions that cater to your modern lifestyle, all while keeping food fresh and organized.