Hotpoint osx 1036n d cx s manual Sliding rack kit assembly, Replacing the light bulb

GB

Sliding rack kit assembly

Inspecting the seals

		A
Left	Right guide
guide rail	rail
B
	C
	of
		Direction
		extraction

To assemble the sliding racks:

1.Remove the two frames, lifting them away from the spacers A (see figure).

2.Choose which shelf to use with the sliding rack. Paying attention to the direction in which the sliding rack is to be extracted, position joint B and then joint C on the frame.

Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

3. Secure the two frames

with the guide rails using the

holes provided on the oven

walls (see diagram). The

holes for the left frame are

situated at the top, while the

holes for the right frame are

Lamp

Holder

compartment

Lamp

Glass cover

1.Remove the glass cover of the lamp-holder.

2.Remove the light bulb and replace it with a similar one: halogen lamp voltage 230 V, wattage 25 W, cap G 9.

3.Replace the glass cover (see diagram).

at the bottom.

4. Finally, fit the frames on

the spacers A.

!Do not place the sliding racks in position 5.

!Do not touch the light bulb directly with your hands.

!Do not use the oven lamp as/for ambient lighting.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

18