How to Keep Your Oven in Shape

Before cleaning your oven, or performing maintenance, dis- connect it from the power supply.

To extend the life of your oven, it must be cleaned frequently, keeping in mind that:

•Do not use steam equipment to clean the appliance.

•the enamelled or stainless steel parts should be washed with lukewarm water without using any abra- sive powders or corrosive substances which could ruin them; Stainless steel could get stained. If these stains are difficult to remove, use special products available on the market. After cleaning, it is advisable to rinse thoroughly and dry.

•the inside of the oven should preferably be cleaned immediately after use, when it is still warm, with hot water and soap; the soap should be rinsed away and the interior dried thoroughly. Avoid using abrasive de- tergents (for example cleaning powders, etc…) and abrasive sponges for dishes or acids (such as limescale-remover, etc…) as these could damage the enamel. If the grease spots and dirt are particularly tough to remove, use a special product for oven clean- ing, following the instructions provided on the packet.

•if you use your oven for an extended period of time, condensation may form. Dry it using a soft cloth.

•it is important to ensure that the seal around the oven door opening is not damaged. Should it be damaged, please contact your nearest After-sales Service Centre. We recommend you avoid using the oven until it has been repaired.

•never line the oven bottom with aluminium foil, as the consequent accumulation of heat could compromise the cooking and even damage the enamel.

•clean the glass door using non-abrasive products or sponges and dry it with a soft cloth.

How to remove the oven door

For a more thorough clean, you can remove the oven door. Proceed as follows:

•open the door fully;

•lift up and turn the small levers situated on the two hinges;

•grip the door on the two external sides, shut it slowly but not completely;

•pull the door towards you, pulling it out of its seat; Reassemble the door by following the above procedures backwards.

Replacing the oven lamp

•Always unplug the appliance from the mains or switch off the main switch before all operations.

•With the aid of a narrow, flat item (such as a screwdriver or a spoon handle, etc...), remove the glass cover.

•Unscrew the lamp and replace it with another featuring the same characteristics:

-voltage 230/240 V

-wattage 15 W

-type E 14

•Replace the glass cover and ensure you reposition the seal correctly.

Oven compartment

Lamp

Seal

Glass door