Fast clean programming

The fast clean cycle time and/or cycle end time can be programmed after selecting the fast clean mode.

Programming the fast clean cycle time

Press button 5 and then adjust the cycle time by turning knob C. Press the OK button to store the setting. The time left until the end of the fast clean cycle will be displayed. Once this time is up, the word “end” will be displayed and a sequence of acoustic signals will be sounded to indica- te that the cleaning cycle is complete.

•Press any button to silence the acoustic signal.

•Turn knobB back to position 0 to remove the word “end” from the display.

For example

It is 9:00 a.m. and a fast clean cycle time of 1 hour and 15 minutes is programmed. The fast clean cycle will end automatically at 10:15 a.m..

Programming the fast clean cycle end time

Press button 4 and then adjust by turning knob C. Press the OK button to store the setting. The time left until the end of the fast clean cycle will be displayed.

When the fast clean cycle time previously selected is up, the word “end” will be displayed and a sequence of acoustic signals will be sounded to indicate that the fast clean cycle is complete.

•Press any button to silence the acoustic signal.

•Turn knob B back to position 0 to remove the word “end” from the display.

For example

It is 9:00 a.m. and the fast clean cycle end time is set at 10:15 a.m.. Fast clean will last 1 hour and 15 minutes.

Delayed fast clean cycle programming

Press button 5 and then adjust the cycle time by turning knob C. Press the OK button to store the setting and display it.

Press button 4 and then adjust the cycle end time by turning knob C. Press the OK button to store the setting and the display will remind you of the cycle end time and of the actual cycle time set alternately.

For example

It is 9:00 a.m. and a fast clean cycle time of 1 hour and 15 minutes and 12:20 as the cycle end time are programmed. The fast clean cycle will start automatically at 11:15 a.m..

The icon A will remind you that you have programmed the fast clean cycle time and/or the cycle end time.

To cancel a programmed time

To cancel any programming you have made, set knob “B” to position “0”.