Hotpoint CH50GCIK manual 600 mm

Page 5

Gas connection

The cooker should be connected to the gas-supply by a Gas Safe registered installer. During installation of this product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience of any subsequent removal or servicing. Connection of the appliance to the gas mains must be carried out according to the prescribed regulation in force, and only after it is ascertained that it is adaptable to the type of gas to be used.On some models the gas supply can be connected on the left or on the right, as necessary; to change the connection, reverse the position of the hose holder with that of the cap and replace the gasket (supplied with the appliance). In the case of connection to liquid gas, by tank, use pressure regulators that conform to the regulation in force. The gas supply must be connected to the left of the appliance. Be sure that the hose does not pass through the rear of the cooker touching hot parts.

HOT PARTS

600 mm

Important: make sure the supply pressure conforms with the values shown in the table entitled “Caracteristics of the burners and nozzles”. When the cooker is installed between cabinets (recessed), the gas connection must be effected by an approved flexible hose with bayonet fitting (BS 669 Current Edition). The gas inlet for the cookers is a threaded G 1/2 gas female fitting.

Connecting the gas supply

To make the connection, a flexible hose should be used corresponding to the current gas regulations which are:

the hose must never be at any point in its lenght in contact with the “hot” parts of the cooker;

the hose must never be longer than 1,5 metre;

the hose must not be subject to any tension or torsional stress and it must not have any excessively narrow curves or bottlenecks;

the hose must be easy to inspect along its entire length to check its condition;

the hose must always be in good condition, never attempt to repair.

Important: the installation must comply with gas safety (installation and use) regulations 1984. In all cases for the above, by low, a qualified,Gas Safe approved engineer must be called for installation.

Disposing of the appliance

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

turn the tap to minimum;

remove the knob and adjust the regulation screw, which is positioned in or next to the tap pin, until the flame is small but steady.

N.B.: in the case of liquid gas, the regulation screw must be screwed in to the bottom.

check that the flame does not turn off when you turn the tap quickly from high to low.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

5

Image 5
Contents CH50GCIK CH50GCIW CH50GCIS Contents Introduction Fig. a Installation600 mm Green and Yellow Electrical connectionCH50GCIK CH50GCIW CH50GCIS Burner and Nozzle SpecificationsAlways Safety InformationExtinguisher is likely to tip the pan over Safety Information NeverFeatures ‘SLOWCOOK’ Control PanelUse of Hotplates HOW to Deal with a FAT FireTo operate the grill proceed as follows Use of GrillUse of Main Oven Soft Margarine Oven Cooking ChartPoints to consider when preparing food for Slow cooking Using the Main Oven for Other FunctionsAdvantages of Slow cooking are OperationCare and Cleaning Cooking Results Not Satisfactory? Hotplate burner SomethingWrong with your Cooker?Technical Characteristics To set the clock Minute minder To cancel a previous setting Electronic timerGuarantee After Sales Service Xerox Fabriano 10/2011
Related manuals
Manual 28 pages 2.75 Kb

CH50GCIK specifications

The Hotpoint CH50GCIK is a versatile and efficient gas cooker designed to meet the culinary needs of every home chef. This model boasts a sleek design and combines modern style with functionality, making it a great addition to any kitchen.

One of the standout features of the CH50GCIK is its dual fuel functionality. It offers traditional gas hobs for precise cooking, allowing users to control the heat instantly. With five gas burners of varying sizes, including a powerful wok burner, this cooker provides flexibility for different cooking techniques, from simmering sauces to stir-frying vegetables.

The oven of the CH50GCIK is equipped with a spacious 70-liter capacity. It is designed to accommodate large meals, making it ideal for family gatherings or entertaining guests. The oven features a fan-assisted cooking system that ensures even heat distribution for perfectly baked goods and roasted meats. With an energy efficiency rating of A, the CH50GCIK minimizes energy consumption while maximizing cooking performance, making it an eco-friendly option.

Another significant characteristic of this cooker is its easy-to-clean enamel interior. The smooth surface helps to prevent food from sticking, making post-cooking cleanup a breeze. Additionally, the telescopic shelves make it simple to access dishes, ensuring a safe and easy cooking experience.

Safety is a priority for Hotpoint, and the CH50GCIK incorporates several safety features, including a flame failure device. This technology automatically cuts off the gas supply if the flame goes out, providing peace of mind while cooking.

The CH50GCIK also includes a built-in grill, providing further culinary options for users. The grill can be used for toasting, grilling, or warming, adding versatility to this already flexible appliance.

Overall, the Hotpoint CH50GCIK is designed with the modern user in mind. Its combination of style, efficiency, and functionality makes it an excellent choice for those looking to enhance their cooking experience. With advanced features and thoughtful design, the CH50GCIK is sure to impress both novice cooks and seasoned chefs alike. Whether you’re preparing a quick weeknight dinner or a lavish feast, this cooker stands out as a reliable and attractive kitchen companion.