Hotpoint HUD61 manual Installation, Mains Connection, Siting the Cooker, Moving the Cooker

Page 4

Installation

WARNING - THIS APPLIANCE MUST GB BE EARTHED.

Mains Connection

Your cooker should have been checked to ensure that the voltage corresponds with your supply voltage, this is stated on the rating plate, which is situated on the outer rear panel.

The model number and serial number are located on the front of the cooker, as shown on the Feature's page.

The cooker must be connected by a competent person such as one who is a, NICEIC registered contractor to a suitable double-pole control unit with a minimum rating of 32A and a minimum contact clearance of 3mm (applicable to newer properties, older properties where a 30A double pole control unit and a minimum contact clearance of 3mm is acceptable).

The double pole control unit should be fitted adjacent to the cooker, in accordance with IEE regulations. The control unit must be within 2 metres of but not directly above the appliance and should be easily accessible in the event of an emergency. The power supply cable should conform to B.S.6004 with a conductor size of 6mm2, minimum.

Access to the mains terminals is gained by removing the rear access cover. The mains cable must pass through the cable clamp adjacent to the terminal block. Sufficient cable should be used to allow the cooker to be pulled out for servicing.

Ensure that the mains cable is routed away from any brackets affixed to the rear panel and is not trapped to the rear wall when pushing the cooker into position between cabinets.

Levelling

Four feet are fitted which can be adjusted up or down to set the height (900mm - 930mm) and level the cooker.

The feet can be simply screwed in or out to lower or raise the cooker.

After the correct height is achieved, lock the feet into position by tightening the locking nut using an open ended spanner.

CAUTION: Some soft floor coverings may get damaged if the cooker is not moved carefully. NOTE: Ensure oven shelves are level by using a spirit level on the rod shelves.

Siting the Cooker

The cooker is designed to fit between kitchen cabinets spaced 600mm apart. The space either side need only be sufficient to allow withdrawal of the cooker for servicing and cleaning.

It can be used with cabinets one side or both as well as in an angled corner setting. It can also be used freestanding.

Adjacent side walls which project above hob level, must not be nearer to the cooker than 150mm and should be protected by heat resistant material. Any overhanging surface or cooker hood should not be nearer than 650mm.

Note: This appliance must NOT be fitted on a platform.

Moving the Cooker

Before moving your cooker, switch off at the cooker control unit, ensure that it is cool.

Open the grill door sufficiently to allow a comfortable grip on the underside front edge of the oven roof, avoiding any grill elements.

Radio Interference

This appliance conforms to EN 55014 regarding suppression of radio and television interference.

Note: Take care in moving the cooker as it is heavy. Take care to ensure that any floor covering is not damaged.

The cooker is fitted with a safety chain that must be attached to a hook, secured to the wall behind the appliance.

This appliance conforms with the following European Economic Community directives:

-2006/95/EC of 12/12/06 (Low Voltage) and subsequent modifications;

-2004/108/EC of 15/12/04 (Electromagnetic Compatibility) and subsequent modifications;

-2009/142/EC of 30/11/09 (Gas) and subsequent modifications (only for models which use gas);

-93/68/EEC of 22/07/93 and subsequent modifications.

-2002/96/EC

-1275/2008 (Stand-by/ Off Mode)

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Instructions for Installation and Use 60cm Dual Fuel Cooker ContentsTo the Installer IntroductionTo the User Retention of this Instruction BookSafety Information Keep the cooker clean, as a build upAlways Grease or fat from cooking can cause aInstallation Mains ConnectionSiting the Cooker Moving the CookerModel Numbers HUD61 Category II2H3+ GBLevelling Electrical Connection Operational ChecksElectrical connection EarthedFeatures Controls Control Knobs for the gas burnersMain Oven Light Cooling FanGrill Control Setting the minute minder Setting the clockProgramming cooking Safety Requirements for Deep FAT Frying HOW to Deal with a FAT FireModels with Hob Gas Burner Safety Devices to Prevent Leaks HotplateTop Oven Cookery Notes Food/utensils must not be placed directly on the oven floorOperation Cooking meat/poultryTemperature and time Main OvenCookery Notes Oven positionsTo USE the Grill GrillingGrill Pan Handle Oven Cooking Charts Beef Lamb 80C PoultryPork 90C Veal 75CCare and Cleaning Oven Heat Clean Linings Cleaning the glass door Side Opening DoorsSomething Wrong with your Cooker? If something still Goes wrongHotpoint Service Cover Parts & Accessories Hotpoint ServiceUK 08448 24 24 Republic of Ireland 01 230 Months Parts and Labour Guarantee Guarantee is subject to the following conditionsGuarantee does not cover Year Parts GuaranteePage Page Xerox Fabriano

HUD61 specifications

The Hotpoint HUD61 is a versatile and stylish built-in double oven designed for modern kitchens. With its sleek appearance and advanced features, this appliance provides both functionality and aesthetic appeal.

One of the standout features of the Hotpoint HUD61 is its impressive cooking capacity, allowing for simultaneous cooking of multiple dishes. The dual oven design includes a large main oven with a capacity of 65 liters and a smaller secondary oven with 39 liters. This arrangement makes it easy to prepare large meals or multiple courses without the hassle of juggling oven space.

The HUD61 is equipped with a fan-assisted cooking system that promotes even heat distribution throughout the cooking space. This technology ensures that dishes cook evenly, reducing the likelihood of hotspots and undercooked areas. The fan also helps to circulate air, which is particularly useful when baking or roasting, leading to beautifully cooked meals every time.

Another key feature of the Hotpoint HUD61 is its programmable digital timer. This intuitive control panel allows users to set cooking times and temperatures, streamlining the cooking process. Whether you're baking, roasting, or grilling, the precise control of the timer means you can achieve perfect results without the constant need to monitor your dish.

For those who appreciate the ease of cleaning, the HUD61 comes with catalytic ovens, which utilize a special coating on the oven walls to break down grease and grime at high temperatures. This means less time spent scrubbing and more time enjoying your culinary creations. Additionally, the oven doors are designed to be easily removable, making the cleaning process even more straightforward.

Energy efficiency is another important aspect of the Hotpoint HUD61. It boasts an excellent energy rating, allowing users to cook delicious meals without impacting their energy bills significantly. This sustainable approach to cooking is increasingly essential for eco-conscious consumers.

In conclusion, the Hotpoint HUD61 is a well-rounded appliance that combines modern technology with practical features. Its spacious double oven, fan-assisted cooking, programmable timer, and easy-clean design make it a valuable addition to any kitchen. Whether you're an amateur cook or a seasoned chef, this oven is designed to help you achieve culinary excellence with ease.
Top Page Image Contents