Hotpoint FDW80 manual Messages In The Display, Cause/How to resolve…, END flashing In Display

Fault Area

Messages In The Display

Issue Cause/How to resolve…

Your dishwasher is designed so that if a fault occurs, an error message will be illuminated in the display, these can consist of words or numbers.

-Inmanycasesyoucanrectifytheseerrorcodesbyfollowing instructions in this section.-

-Ifhowevertheerrorcodedisplayedonyourmachineisnotlisted, youwillneedtocontactyourServiceCentreforassistance.

See “Key Contacts” on the back page of the instruction book.

-ProgrammeTimeErratic	- This is normal – the Rinse Phase indicator will be highlighted,
	astheprewashprogrammeisarinsecycle.

Programme time example

-RinsePhaseIndicatorHighlighted WhenPre-WashSelected.

Pre-wash Programme

Rinse Phase Indicator

-“H20” or AL06 – Water Tap Off

Or

-END flashing In Display

-Indicatesendofprogramme

On/off Button

IfH20isilluminatedinthedisplay,turnonthewatertapandthe dishwasherwillstartafterafewminutes.

Alternatively:

-If you are not at your dishwasher when “H20” is displayed, the dishwasher will switch to alarm mode and the Code “AL06” will flash in the display.

FollowtheinstructionsbelowtocanceltheAL06code:

Step 1: Press & hold the “On/Off” button until 4 dashes appear

inthedisplay.

Step 2: Turn on the water tap

Step 3:Wait approximately 20 seconds and then switch the

appliance onbypressingthe“On/Off”button.

Step 4: Selectwashprogrammeasnormal.

Please Note:

If the above does not solve the problem, check that the water feed pipe filter is not blocked.

“END” will flash in the display at one-second intervals to indicate theprogrammeiscomplete&themachineisinstandbymode.

-Press&holdthe“On/Off”buttontoswitchoffthedishwasher.

Please Note:

When your dishwasher is switched back on, “END” will continue to flash in the display until a new programme is selected – This is normal.

16