Hotpoint HDA850G warranty Careand Cleaning, How to change color panek, To change color panels

Page 11

- Careand Cleaning

USER MAINTENANCE

INSTRUCTIONS

Built-in dishwashers often use an air gap. Keepit clean. ~

An air gap is a plumbing device. It protects your dishwasher against water backing up into it if a drain clogs. The air gap is not a part of the dishwasher. And you may not even have one. Not all plumbing codes require air gaps.

—.

[f you have an air gap, check it at least once a month. THE AIR GAP IS N~ PART OF YOUR DISHWASHER. IT IS NOT COVERED IN YOUR WARRANTY.

How to change color panek

Your dishwasher comes with reversible and interchangeable front panels. Both door and access panels are held in place by the panel trim. Each side of each panel is finished in a different color.

To change color panels:

1. Take out two screws

from door ~nd two

jCreW5 from access panel. Then remove the side trims from either

side of the dishwasher.

The air gap is easy to clean. With most types, first turn off the dish- washer, then lift off the chrome cover. Then unscrew the plastic cap and check for any build-up of grit. A toothpick makes cleaning easy.

Check the air gap any time your dishwasher isn’t draining well.

To keep your dishwasher looking good. . .

Clean the control panel with a lightly dampened cloth. Dry thoroughly. Do not use abrasives or sharp objects on the panel. They can damage it.

Clean the outside with a good appliance polish wax. The outside cabinet finish is durable, but it can scratch. So use no scouring pads, harsh or gritty cleaners.

Appliance Polish Wax & Cleaner (Cat. No. WR~X216) is available from Hotpoint Appliance Parts Marts.

The inside usually takes care of itself. If it should ever need cleaning, use a mild cleansing powder~Scouring pads and h;rsh cleaners can mar the finish.

2.Slide out the panels and replace them with the color you want in front.

3.Replace the side trims.

Note: Do not operate dishwasher while changing panels or when lower access panel is removed.

How to prepare your dishwasher for winter storage

If the dishwasher is to be left unused in an unheated location during the winter months, have a service technician take the follow- ing steps to prevent the machine from freezing:

c Remove fuses or trip circuit breakers to remove electric power from the dishwasher.

Turn off water to dishwasher. Disconnect the water inlet line from the water valve and drain.

Remove water valve from the dishwasher and blow on small plastic outlet to remove water.

Replace water valve and water line.

Remove plug in bottom of rubber boot and drain completely. Replace the plug.

Special lA” thick wood inserts can replace the two metal panels. Dimensions for %“ wood inserts: Door Panel: 23 %“W x 16*zb”H. Access Panel: 23 lA”W x 61A”H.

Other special finishes can be applied to the metal panels to match your kitchen decor.

11

Image 11
Contents Dishwasher If you received Dam~ed dishwasher Save time and money. Before you request serviceHelp us help you Ene~y-saving tipsTo minimize the possibility of injury Read all instructions before using this applianceFor Rinse Hold cycle Be sure door is unlatched How to operate your dishwasherFor Pots & PANS, Normal WNH and Light Wash cycles Bave the door unlatched Cycle selection hintsWhat happem in each cycle For Plate Warmer cycleMod dishwashing stirts with H~ water How to choose and use the right detergentWhat you can leave on dishes What you shouldn’tDete~ent UsWe Guide powder or liquid How to load your dkhwasher How to load the ~PMCK How to load the Bottom WCK Exceptions not safe Special Instructions Numinum Fo~et a dish? Here’s when vou can add itHow to add a forgotten dish Usually MaterialTo keep your dishwasher looking good Careand CleaningHow to change color panek How to prepare your dishwasher for winter storageFurther than n~essary to start the dishwasher ~. Use This Problem SolverQuestions? To remove severe spots and film from glassware SP~S and Filming on GlassesSuds in the TUB If You Need Service Warranty