Hotpoint BFT68 manual Before Using your Dishwasher, Unscrew the salt container cap

D ISHWASHER

Before Using your Dishwasher

Adjusting the water softener.

Your dishwasher can adjust its salt consumptionaccordingtothehard- ness of the water in your home. This way, you can optimise and customise your dishwasher's salt consumption.

To adjust salt consumption, do as follows:

1.Unscrew the salt container cap

2.There is an arrow on the neck of the container (see figure): if necessary, turn the arrow anti-

clockwise from the "-" setting to the "+" setting.

Select the arrow position depending on the water hardness, referring to the table.

Water Hardness
				Salt	Autono-
				consu-
Clarke			Selector		my
	°fH	mmol/l		mption
degrees			position		(cycles\2-
				(grams/-
					kg)
				cycle)
0 - 14	0 - 17	0 -1,7	/	0	/
14 - 36	18 - 44	1,8 - 4,4	"-"	20	60
36 - 71	45 - 89	4,5 - 8,9	MED	40	40
>71	>89	> 8,9	"+"	60	25

You don't know how hard the water in your home is? Ask the company that supplies water in your area.

Salt

Filling the salt container. When to add salt:

Always use salt which is intended for dishwasher use.

The salt container is situated underneath the lower basket, fill it up as follows:

1.Pull out the lower basket completely, unscrew and remove the container cap

2.If it is the first time you add the salt, first fill the container up with water (you won't have to do this againnexttime)

3.Put the dishwasher funnel on the hole and pour in approximately two kilos of salt. It is normal that some water comes out of the container.

4.Screw the cap back in place carefully.

The salt container should be filled up when the low salt indicator light “E” flashes on the control panel.

When you have loaded salt for the first time, it is normal for the low salt indicatorlighttostayonforatleast5 consecutive cycles.

9