Hotpoint CSX24X warranty Solid State Monitor System, When your refrigerator is first plugged

Solid State Monitor System

It keeps an eye on things for you.

@Red signal light flashes to tell you when either door is open.

@Green signal light tells you[hat the Door Alarm beeper has been set to sound after either door has been open 30 seconds.

@Red signal light tells you when freezer foodkeeping temperature is above normal.

@Green lighted word NORMAL indicates that no failure has been detected by the diagnostic system.

@Flashingdiagnosticcodes in the display warn you when:

❑frozen foods should be checked.

m

Epower has been interrupted.

❑icemaker may not be operating properly.

❑- defrost system has failed.

❑freezer control may need to be set for a colder temperature.

What these codes mean—and what to do when they appear—is summarized on the inside of the freezer compartment door and explained more thoroughly on the following pages.

@Status Check pad puts a review of the electronic diagnosis of five coded functions at your fingertip and also allows you to erase codes from display.

@Electronic control allows you to turn night light in water-and-ice service on and off.

When your refrigerator is first plugged in.. .

All panel lights come on for five seconds, a beep sounds, and lights go off except as follows:

●PF tlashes in the display. Touch STATUS CHECK-RESET pad to erase it.

●Green word NORMAL glows.

●Red WARM TEMPERATURE light glows if freezer compartment temperature is higher than normal. It goes off when proper foodkeeping temperature is reached.

●Door alarm beeper is activated and green light on DOOR ALARM pad glows.

●Red DOOR OPEN I ight flashes if either door is open, goes out when doors are shut.

. Night light in water-and-ice service is off.