Care and maintenance

Switching the appliance off

GB	Disconnect your appliance from the electricity
	Disconnect your appliance from the electricity
	supply before carrying out any work on it.

Cleaning the appliance

•The stainless steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. Use specialised products for the removal of stubborn stains. After cleaning, rinse and dry thoroughly. Do not use abrasive powders or corrosive substances.

•The inside of the oven should ideally be cleaned after each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth. Do not use abrasive products.

•All accessories can be washed like everyday

crockery, and are even dishwasher safe.

Never use steam cleaners or pressure cleaners on the appliance.

Inspecting the seals

Check the door seals around the oven at regular intervals. If the seals are damaged, please contact your nearest After-sales Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

		1. Remove the
	Oven	glass cover of the
	compartment	lamp-holder.
		lamp-holder.
		2. Remove the
	Lamp	light bulb and
	Lamp	replace it with a
		replace it with a
		similar one:
	Glass cover	halogen lamp
	Glass cover	voltage 230 V,
		voltage 230 V,
		wattage 25 W,
		cap G 9.
	3. Replace the glass cover (see diagram).

Cleaning the oven door

Clean the glass part of the oven door using a sponge and a non-abrasive cleaning product, then dry thoroughly with a soft cloth. Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack.

For more thorough cleaning purposes, the oven door may be removed:

1.Open the oven door fully (see diagram).

2.Use a screwdriver to lift up and turn the small levers F located on the two hinges (see diagram).

3. Grip the door on the two outer sides and close it approximately half way. Pull the door towards you lifting it out of its seat (see diagram). To replace the door, reverse this sequence.

Do not touch the light bulb directly with your hands.