Sunbeam EM8900 Sunbeam’s Safety Precautions, Safety Precautions for Your Sunbeam Espresso Machine

Page 3

Sunbeam’s Safety Precautions

SAFETY PRECAUTIONS FOR YOUR SUNBEAM ESPRESSO MACHINE

Always place the unit on a flat, level surface.

Do not operate without water in reservoir. Fill reservoir with only clean and cold water. Observe the maximum filling volume is 3 litres.

Do not remove the filter handle during the espresso pour or water flow as the unit is under pressure. Removing the filter handle during either of these operations can lead to a scalding or injury.

The steam wand and hot water tap become very hot during texturing milk and water flow. This may cause burns in case of contact,

therefore avoid any direct contact with the steam wand or hot water tap.

Always disconnect the plug from the power outlet prior to cleaning the espresso machine or if there is any problem during the coffee making process.

Do not allow the power cord to come into contact with the hot parts of the espresso machine, including the cup warming plate, hot water tap and steam wand.

Do not place hands directly under the steam, hot water or coffee pour as this can lead to a scalding or injury.

Sunbeam are very safety conscious when designing and manufacturing consumer products, but it is essential that the product user also exercise care when using an electrical appliance. Listed below are precautions which are essential for the safe use of an electrical appliance:

Read carefully and save all the instructions provided with an appliance.

Always turn the power off at the power outlet before you insert or remove a plug. Remove by grasping the plug - do not pull on the cord.

Turn the power off and remove the plug when the appliance is not in use and before cleaning.

Do not use your appliance with an extension cord unless this cord has been checked and tested by a qualified technician or service person.

Always use your appliance from a power outlet of the voltage (A.C. only) marked on the appliance.

Close supervision is necessary when your appliance is being used near children or infirm persons.

Never leave an appliance unattended while in use.

Young children should be supervised to ensure that they do not play with the appliance.

Do not use an appliance for any purpose other than its intended use.

Do not place an appliance on or near a hot gas flame, electric element or on a heated oven. Do not place on top of any other appliance.

Do not let the power cord of an appliance hang over the edge of a table or bench top or touch any hot surface.

For safety reasons and to avoid maintenance by unskilled persons, some appliances are ‘sealed’ using tamperproof screws. Such appliances should always be returned to the nearest Sunbeam Appointed Service Centre for adjustment or repair if required.

Do not operate any electrical appliance with a damaged cord or after the appliance has been dropped or damaged in any manner. If damage is suspected, return the appliance to the nearest Sunbeam Appointed Service Centre for examination, repair or adjustment.

For additional protection, Sunbeam recommend the use of a residual current device (RCD) with a tripping current not exceeding 30mA in the electrical circuit supplying power to your appliances.

Do not immerse the appliance in water or any other liquid unless recommended.

If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.

Ensure the above safety precautions are understood.

2

Image 3
Contents Page Important instructions retain for future use ContentsSafety Precautions for Your Sunbeam Espresso Machine Sunbeam’s Safety PrecautionsAbout espresso coffee Removable drip tray and grill Height adjustable rubber feetWarming plate Variable steam control dial Steam wandLitre water reservoir Low water warning indicator AccessoriesProgrammable control panel Hot water control dial Hot water wandTptt System Simultaneous Use Twin Pump and Twin Thermoblock Tptt SystemAnti Calc Filter Commercial Size Group Head & Filter HandleControl Panel Pre-InfusionSingle Espresso Using the control panelPower ManualUsing the control panel Double EspressoProgram Using the control panel Preparing the espresso machine Reference guide to using your espresso machineMaking the espresso Reference guide to using your espresso machineProgramming Press the double espresso button to start and end the pour Texturing milkHot water Cleaning Remove filter handle from the group head Programming Double Espresso Resetting the Factory SettingsProgramming your espresso machine Programming Single EspressoProgramming your espresso machine Preparing your espresso machine before use Dosing and Tamping Guide to the perfect espressoPreheat Glasses Preheat Filter Handle and Filter BasketSleep Mode Guide to the perfect espressoCaring for your Espresso Machine Important Do not boil the milk Guide to milk texturingUsing the hot water dispenser Espresso Short Black Espresso recipesCaffe Latte Espresso recipesGroup head rubber seal Care and cleaningDrip tray and grill Group head, filter handle & filter basketsStarting the cleaning cycle Cleaning the group headCare and cleaning Preparing for the cleaning cycleCleaning the group head Descaling solution DescalingDescaling the espresso machine Descaling Australia 1800 025 New Zealand 0800 786 Consumer Hotline

EM8900 specifications

The Sunbeam EM8900 is a versatile and efficient espresso machine that has carved a niche in the home coffee brewing market. This model is designed for coffee enthusiasts seeking to replicate barista-quality espresso at home, bringing a blend of technology, ease of use, and robust performance.

One of the notable features of the Sunbeam EM8900 is its powerful 15-bar pump system, which is essential for brewing authentic espresso. This pressure ensures that water extracts the rich flavors and aromas from the coffee grounds, resulting in a full-bodied beverage. Coupled with a stainless-steel boiler, the machine heats water quickly and efficiently, reducing waiting time between brewing sessions.

The EM8900 is equipped with a built-in steam wand, allowing users to froth milk for lattes and cappuccinos. The steam wand is designed for easy maneuverability, making it simple to create creamy microfoam and textured milk. The machine also comes with a dual-action filter holder, including a single and double filter basket, which provides flexibility for different brewing preferences. This feature enables users to experiment with their favorite coffee beans and discover their perfect blend.

In terms of user experience, the Sunbeam EM8900 boasts a straightforward interface with easily accessible controls. The machine features indicators for water levels and temperature, ensuring users can monitor their brewing process effectively. The 1.5-liter removable water tank is another practical attribute, offering sufficient capacity for multiple servings without constant refilling.

Cleaning and maintenance are also important considerations. The EM8900 has a drip tray and a removable brew head, making it easy to clean after each use. Regular upkeep of the machine is straightforward, ensuring longevity and consistent performance.

Moreover, the design of the Sunbeam EM8900 combines aesthetics with functionality. The sleek stainless-steel finish not only enhances its appearance but also guarantees durability. Its compact size allows it to fit seamlessly in any kitchen without taking up too much counter space, appealing to both casual coffee drinkers and serious aficionados.

In summary, the Sunbeam EM8900 stands out in the espresso machine market due to its combination of advanced features, user-friendly design, and high-quality output. Whether you’re making a quick espresso shot or indulging in a frothy cappuccino, this machine provides the tools needed to make your coffee experience exceptional. Its balance of technology and simplicity makes the Sunbeam EM8900 a worthy addition to any coffee lover’s kitchen.