Using your Sunbeam MultiMincer® (continued)
Fitting and using the Kebbe attachments
1.Place the mincer body, facing you on a level, dry surface.
2.Fit the mincing screw inside the chute.
3.Fit the kebbe shaper.
4.Fit the kebbe cone over the shaper.
5.Secure the kebbe attachments with the fastening dial. Loosely secure with fastening dial – do not use spanner until chute is locked into mincer body. See figure 5.
Figure 5
6.Align chute into the mincer body using arrows as a guide. Press and hold the lock/unlock button to twist and lock into place. Use the spanner to tighten the fastening dial to ensure all elements are securely in place.
7.Place the feeder tray on top of the chute. See Fig 6.
Figure 6
8.Plug the power cord into a
9.Switch on mincer.
10.Using the pusher, push the kebbe mixture into the chute.
11.Cut kebbe into desired lengths.
Tip: For full kebbe recipe and suggestions see page 20.
9