Troubleshooting Guide
Problem . . . | Solution . . . | |
|
| |
Blender fails to start | • Check to see if unit is securely plugged into an electric outlet. | |
or stops while it is | • Check to see if the integrated circuit breaker has tripped and reset it, if needed. | |
running and cannot | • Check to see if the fuse for the electric outlet has blown or if a circuit breaker | |
be restarted | ||
has tripped. | ||
| ||
| • If the motor stops during operation due to overheating, unplug and allow the unit | |
| to cool down for 15 minutes. Plug unit back after 15 minutes to resume normal | |
| operation. | |
|
| |
Ingredients will not mix | • Check to see if enough liquid has been added to the ingredients. Mixture should | |
properly | be fluid and | |
| • Solid pieces are too large. Pieces should not exceed 1" cubes. | |
| • Container is too full. Do not fill past highest graduation marking. | |
| • Cutter unit blades are not sharp or are damaged. Inspect container and cutter | |
| assembly daily. Replace cutter assembly at least every 90 days or sooner if cutter | |
| assembly appears worn or damaged. | |
| • Check to see if cutter assembly is installed properly. | |
| • Select speed to create a fluid blend. | |
|
|
Maintenance
Inspect the blender and its various parts and replace as follows:
Daily | Unplug the blender and remove the container from the base, and then inspect the |
| container and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if |
| necessary. If the blades are loose, discontinue use immediately and replace the blades. |
| Do not attempt to repair or tighten the cutter assembly. See “Technical Service” . |
|
|
Weekly | Unplug the blender, and then inspect the power cord insulation and power plug for cracks. |
| Refer to “Technical Service” for repair or replacement. |
Quarterly | Replace the container and cutter assembly at least every 90 days. See “Technical Service”. |
|
|
9