Denon AVR-2803/983 manual Auto, Test Tone 5dB 0da 0dB, Flashing 0dB, Effl

Select the mode.

Select "Auto" or "Manual".

• AUTO:

4Adjust the level while Eistening to the test tones produced autematicaEly from the different speakers.

•Manual:

Select the speaker from which you want to produce the test tone to adjust the level.

Channel Level

i

,_Test Tone _4:_

Test Tone Start [)_<

Level Clear [i_4

Example: When the "Auto" mode is selected

Select "Test Tone Start".

Channel Level

Test Tone _4:_

_Test Tone Start [%_4

7			a. if the "Auto" mode is selected:
			Test tones	are automaticaly	emitted	from the different speakers.
			The test tones are emitted from the different speakers in the
			following order, at 4-second intervals the first time and second dme
			around, 2-second intervals the third time around and on:
					._		I spkr
						2spkrs
			When the	surround back	speaker setdng		is set to "lspkr"	for
			"Speaker Configuration", this is set to "SB".
b	_	_	Use the CURSOR left and right buttons			to adjust	all the speakers to	the
_,:t	_	/r_]_	same volume.
\_/		"_4"_	The volume can be adjusted		between	-12 dB	and +12 dB in units	of
		"% osdR

b. When the "Manual" mode is selected Use the CURSOR up and down to select the speaker for which you want to output test tones, then use the CURSOR left and right to adjust so that the volume of the test tones from the various speakers is the same.

%After the above settings are completed, press the ENTER button. The "Channel Level" screen reappears.

Level Clear [_4

Test	Tone
	_FL	<-1 1.	5dB_
	FR	0.	0da
	SR	0.	0dB
	SBR	0, 0dB
B	C	0.	0dB
	SBL
Flashing	SL	0.	0dB
	SW	0.	0dB

Example: When the volume is set to-115 dB while the test tone is being produced from the Front Lch speaker

Test	Tone
	EFFL	<--11.	5dB)
	FR	0.	0dB
	SR	0.	0dB
	SBR	0.	0dB
B	C	0,.	0dB
	SBL
Flashing	SL	0.	0dB
	SW	0,	0dB

Example:When the volume is set to -t 15 dB

while the Front Lch speaker _s selected

To cancel the settings, select "Level Clear" and "Yes" on the "Channel Level" screen, then make the settings again.

The level of each channel should be adjusted to 75 dB (C-weighted, slow meter mode) on a sound level meter at the listening position.

If a sound level meter is not available adjust the channels by ear so the sound levels are the same. Because adjusting the subwoofer level test tone by ear is difficult, use a well known music selection and adjust for natural balance.

NOTE: When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer's own volume control.

22