Wells F-886 operation manual Cleaning Instructions, Preparation, Frequency, Tools

Page 11

CLEANING INSTRUCTIONS

DANGER: BURN HAZARD

Contact with hot oil will cause severe burns. Allow the fryer to cool before cleaning. Always wear protective clothing and heat resistant gloves when cleaning the fryer.

PREPARATION

Turn temperature control to OFF

 

Allow fryer to cool completely before cleaning

 

Disconnect fryer from electric power before

 

cleaning

FREQUENCY

Daily, or as needed

TOOLS

Mild Detergent, Non-abrasive cleanser

 

Soft Cloth or Sponge, Plastic Scouring Pad

 

Container for disposal of used oil.

 

 

 

 

CLEANING

 

1. Turn temperature control to OFF. Disconnect from electric power.

CAUTION:

Electric Shock

Hazard

Disconnect fryer from electric power before cleaning.

CAUTION:

Burn Hazard

Allow fryer to cool completely before cleaning.

2.Remove fry baskets, then swing the element heads up and out of the frypots.

NOTE: The element support rod is spring-loaded. When the element head is raised, the support rod will automatically swing into position to keep the element head raised.

3.Allow the oil to cool to a safe temperature (120ºF or less). Carefully remove the frypots: wearing heat-resistant gloves, lift the frypots by the handles. Drain the oil into a suitable container.

4.Frypots and baskets may be washed in a dishwasher, or with warm water and mild detergent. Rinse thoroughly and dry completely.

5.Wipe/brush all crumbs, breading and cooking debris from the elements. Pay particular attention to the area between the element and the thermobulbs. Be careful that the capillary tubes of the thermobulbs are not moved or damaged during cleaning.

6.Keep all exterior surfaces free from splashed grease by wiping with

aclean cloth dampened with warm water and mild detergent. A non-abrasive detergent and plastic scouring pad may be used for stubborn deposits.

IMPORTANT: DO NOT use steel wool or abrasive cleansers as these will damage the surface finish.

IMPORTANT: DO NOT submerge fryer in water. DO NOT spill or pour water into controls, control panel or wiring. Damage to internal components will occur.

7.Be certain frypots are completely dry, then reinstall in fryer.

a.Be sure the TEMPERATURE CONTROL KNOB is turned to OFF, then plug unit into receptacle.

b.Lower the ELEMENT HEADS into the frypot by pushing back on the ELEMENT LIFTING HANDLE, raising the SUPPORT ROD, then carefully lowering the elements.

c.Add new or filtered oil to the MIN OIL line in frypots

Procedure is complete.

CAUTION:

Electric Shock

Hazard

Do not submerge fryer in water.

IMPORTANT: DO NOT spill or pour water into controls, control panel or wiring.

DO NOT submerge fryer in water. Damage to internal components will occur.

Damage to internal components from water damage is not covered by warranty.

IMPORTANT: DO NOT use steel wool or abrasive cleansers for cleaning the fryer cabinet or frypot.

To remove carbonization from elements and frypot, see

PERIODIC CLEANING, page 12.

IMPORTANT:

Nickel plated frypot must be dried completely in order to prevent rusting, and to eliminate water contamination of the cooking oil.

9

Image 11
Contents Important do not Discard this Manual 314Limited Warranty Statement Introduction Table of ContentsSpecifications Features & Operating Controls Risk Damage Precautions and General InformationUnpacking & Inspection InstallationCUT-OUT and Installation Agency Listing InformationFryer Electrical Installation InstallationNormal Operation OperationOperation Fire Hazard OPERATION-SAFETY Test SystemFrequency Cleaning InstructionsCleaning PreparationOIL Disposal Disposal of Used OILSlip and Fall Hazard Health HazardDescription Possible Problem Suggested Remedy Troubleshooting SuggestionsPeriodic Cleaning MaintenanceWells Manufacturing Co Parts & ServiceDescription

F-886 specifications

The Wells F-886 is a notable aircraft within the category of military aviation, particularly recognized for its role in reconnaissance and surveillance missions. Developed by Wells Aircraft, the F-886 incorporates a blend of advanced technologies and features that enhance its operational capabilities.

One of the defining characteristics of the F-886 is its aerodynamic design, which significantly improves speed and agility. The aircraft features a sleek fuselage and specialized wing structure, allowing it to maintain high performance even at considerable altitudes. It boasts a maximum speed of over 600 knots, making it one of the faster aircraft in its class.

The F-886 is equipped with state-of-the-art avionics systems that provide real-time data and situational awareness. The cockpit incorporates multifunction displays, advanced navigation systems, and heads-up displays, ensuring that pilots have access to crucial information at their fingertips. The integration of artificial intelligence in its systems enhances decision-making and operational efficiency, empowering crews to engage in complex missions with confidence.

Another key feature of the F-886 is its modular design, which allows for easy upgrades and customization. This versatility enables operators to adapt the aircraft for various roles, from ground attack to electronic warfare operations. The F-886 can be fitted with an array of sensors, including electro-optical and infrared systems, to improve target acquisition and tracking.

The aircraft's robust propulsion system contributes to its performance, featuring turbofan engines known for their reliability and fuel efficiency. This capability allows the F-886 to conduct long-range missions without the need for frequent refueling, extending its operational reach.

Moreover, the F-886 is designed with advanced stealth technology to minimize its radar cross-section, enhancing survivability in hostile environments. This characteristic, combined with its speed and agility, ensures that the aircraft can operate effectively in high-risk scenarios.

In summary, the Wells F-886 is a sophisticated military aircraft that combines speed, agility, and cutting-edge technology, making it a valuable asset for modern air forces. Its advanced avionics, modular design, and stealth features position it as a formidable player in the realm of military aviation, highlighting its importance in contemporary warfare.