Wells HC-2256, HC-1006, HC-1256, HC2256 operation manual General Operational Notes, HOT Surface

Page 7

GENERAL OPERATIONAL NOTES

Carefully read the description of the hotplate operation on the specification sheet.

DO NOT attempt to perform any maintenance or service unless the hotplate is disconnected from electrical power.

DO disconnect the hotplate from electrical power or turn the circuit breaker off before cleaning or servicing.

DO NOT use steel wool or abrasive cleansers to clean the ceramic top.

DO use the supplied scraper to remove burned-on food product.

OPERATION

Each heating element is controlled by an infinite switch temperature control:

OFF removes power from the element LOW thru 8 are temperature settings Higher numbers indicate higher temperatures

There is a continuous range of settings between LOW and HI HI is a continuous ON setting

The power indicator light will glow any time the temperature control is on.

The hot surface indicator light will glow any time the ceramic surface is approximately 150ºF (65ºC) or higher.

Cooking Recommendations:

Save energy by turning the temperature control off any time the hotplate is not in use. The heating elements will provide full heat within 30 seconds, making it unnecessary to leave the unit on during intermittent use.

Each heating section can hold up to a 16 quart pot or pan. For efficient heating of food product, pots and pans should be no more than 10” in diameter. Maximize the efficiency of the ceramic top by using flat-bottom pots and pans.

Preserve the luster of the ceramic cook surface by wiping up spills promptly and by cleaning frequently. Allow the hotplate to cool completely before cleaning. Use only cook-top cleaning crème on glass-ceramic cooking surfaces.

Stir thick liquids frequently to maintain a consistent temperature.

OPERATION

CAUTION:

HOT SURFACE

Exposed surfaces

can be hot to the touch and may cause burns.

CAUTION:

HOT SURFACE

Ceramic cooking surfaces are hot anytime the

HOT SURFACE indicator light is lit.

DO NOT touch the cooking surface if the HOT SURFACE light is lit.

Fig. 4 Temperature Control

IMPORTANT:

The dial markings are an INDICATION of temperature only. The temperature of the food product depends on many factors, including the size, shape and material of the food container, and the quantity and consistency of the food product.

5

Image 7
Contents Important do not Discard this Manual BUILT-IN Ceramic HotplatesLimited Warranty Statement Introduction Table of ContentsSpecifications Specifications Export ModelsHotplate Unit Features & Operating ControlsControl Unit STD Export Models Only Precautions and General InformationElectric Shock Hazard Risk DamageElectrical InstallationUnpacking & Inspection PreparationHOT Surface General Operational NotesOperation OperationTools Cleaning InstructionsCleaning FrequencyCUT Hazard Special Care InstructionsSymptom Possible Cause Suggested Remedy TroubleshootingParts & Service Description Service Part no