DeLonghi ECAM23.450 manual Setting Water Hardness, Water Softener Filter, Measuring water hardness

10.When the water tank is completely empty, “ Rinsing complete Confirm?” is displayed.

11.Press the button.

12.Insert the filter (if it was present) in the tank, fill the water tank again and the appliance is ready for use.

SETTING WATER HARDNESS

The DESCALE! message is displayed after a period of time established according to wa- ter hardness. The machine is factory set for a hardness value of 4. The machine can also be programmed according to the hardness of the mains water in the various regions so that the machine needs to be descaled less often.

Measuring water hardness

1.Remove the “TOTAL HARDNESS TEST” indi- cator paper attached to this manual from its pack.

2.Immerse the paper completely in a glass of water for one second.

3.Remove the paper from the water and shake lightly.

After about a minute, 1, 2, 3, or 4 red squares form, depending on the hardness of the wa- ter. Each square corresponds to one level.

Level 1

Level 2

Level 3

Level 4

Set water hardness

1.Press the P button to enter the menu.

2.Turn the selection knob to select “ Water hardness “.

3.Confirm the selection by pressing the

button.

4.Turn the selection knob and set the level shown by the indicator paper (see previous paragraph).

5. Press the	button to confirm the set-
ting.

6. Press the button to exit the menu.

The machine is now reprogrammed with the new water hardness setting.

WATER SOFTENER FILTER

Certain models are fitted with a water softener filter. If this is not the case with your model, you are recommended to purchase one from De’Lon- ghi Customer Services.

To use the filter correctly, follow the instructions below.

Installing the filter

1.Remove the filter from the packaging.

2.Turn the date indicator disk (see fig. 30) until the next 2 months of use are displayed.

Please note

The filter lasts about two months if the appliance is used normally. If the coffee maker is left unu- sed with the filter installed, it will last a maximum of three weeks.

3.Remove the tank from the appliance and fill with water.

4.Insert the filter in the water tank and immerse it completely for ten or so seconds, sloping it to enable the air bubbles to escape (fig. 31).

5.Insert the filter in the filter housing (fig. 32A) and press as far as it will go.

6.Close the tank with the lid (fig. 32B), then

replace the tank in the machine.

When you install the filter, you must notify the appliance of its presence.

7.Press the P button to enter the menu;

8.Turn the selection knob (fig. 8) until “Install filter” is displayed;

9.Press the button;

10.The message “Activate?” is displayed.

11.Press the button to confirm the selec- tion. “ Hot water Confirm?” is displayed.

12.Position a container with a minimum capaci- ty of 100 ml under the hot water spout.

13.Press the button to confirm the selec- tion. The appliance begins delivering hot water and the message “ Please wait... “ is displayed.

14.After delivery, the appliance returns automa- tically to the “Ready for coffee” position.

The new filter is active and indicated by an aste- risk displayed under “Install filter” in the menu. You can now use the coffee maker.

19