DeLonghi DCU500T manual Installation, HOW to Make Coffee, Ready

Page 6

INSTALLATION

Place the appliance on a surface far away from water faucets and sinks.

Check that the voltage of the electrical mains cor- responds to the voltage shown on the appliance rating plate.

Connect the appliance only to an efficiently grounded power outlet with a minimum rating of 10 A. The manufacturer may not be considered liable for possible incidents caused by failure to adequately ground the outlet.

Never install the appliance in a room where the temperature may reach 32°F/0°C or lower (the appliance may be damaged if the water free- zes).

Lift the cover by pressing down and turning counterclockwise. Remove the internal parts (fil- ter basket and pump tube).

Wash the internal parts in warm water.

Do not immerse the appliance in water, but sim- ply rinse the inside with water and wipe with a sponge and detergent if necessary. Rinse and dry thoroughly.

HOW TO MAKE COFFEE

Place the appliance on the base without plug- ging into the outlet.

Open the cover by pressing on the knob and turning counterclockwise until it releases from the handles.

Fill with cold fresh water to the mark for the number of cups you want to make. Do not fill above the level of 50 or 60 cups (depending on model). Check the amount of water filled on the level indicator.

NEVER FILL BEYOND THE MAXIMUM LEVEL OF 50 OR 60 CUPS (DEPENDING ON MODEL)!

Wet the filter basket (D – this keeps the ground coffee from sticking). Add coffee to filter basket using a standard tablespoon or a measuring cup. We recommend percolator or course ground coffee for best results. Table 1 shows the recommended amounts of coffee.

Place the filter basket on the pump tube (F).

Then place the tube-basket assembly inside the urn, making sure the pump tube is correctly positioned at the center of the boiler.

Lock the cover into the urn. To do this correctly, press down on the cover and turn clockwise (fig.

1)until it hooks into the tabs of the handles.

C A U T I O N :

NEVER OPE-

RATE THE

APPLIANCE IF

THE COVER IS

NOT SECURELY

FASTENED.

Plug the power cord into the 1 outlet; press the

On/Off button (P) and the On/Off light (Q) will come on. The brewing begins within seconds.

You can see the coffee percolating action through the

glass knob.

When it stops and the green

READY

light

 

(O) illuminates,

 

the

coffee

is

 

ready to

serve

 

using

 

the

2

d i s p e n s i n g

 

lever (fig. 2).

 

Keep Warm and Freshness Indicator Functions

(Select Models Only)

 

When the

coffee

 

brewing

cycle

is

 

completed

and

 

percolating

stops,

 

the

coffee

 

urn

 

automatically swit-

 

ches

to

the

KEEP

 

WARM cycle.

 

 

On the models with

3

a thermostat, select

 

the

keep

warm

 

temperature by turning the knob to the desired position (fig. 3). Some models have a FRESHNESS indicator that shows how long it has been since the last coffee was brewed. When the coffee is just made, the light turns green, and every 20 minutes a triangle segment of the light becomes red.

When the entire light is red, this means that at least 1 hour has passed since the last preparation. The coffee is kept warm as long as the appliance is on.

6

Image 6
Contents Fiducia Italiana S.A DE C.V DCU500T / DCU600T DCU720 Page Important Safeguards Safety Precautions DescriptionNever OPE Rate Appliance if Cover is Not Securely Fastened InstallationHOW to Make Coffee ReadyCare and Cleaning