Juniper Networks 8 manual Installing an SRP I/O Module, Installing an SRP Module

ERX 8.0.x Hardware Guide

NOTE: Install the SRP I/O module before you install the SRP module; otherwise, the system diagnostics will fail.

Installing an SRP I/O Module

To install an SRP I/O module:

1.Ground yourself by using an antistatic wrist strap or other device and connect it to the ESD grounding jack on the chassis.

2.With a Phillips screwdriver, loosen the captive screws that secure the blank filler panel covering the empty chassis slot, if present, and remove the filler panel.

3.Remove the SRP I/O module from its antistatic bag, being careful not to touch module components, pins, leads, or solder connections.

4.Slide the module into the chassis by placing it between the guides of the selected slot and pushing the module until it stops.

NOTE: See the figures in “ERX Overview” on page 3 for module locations.

5.Tighten the module’s captive screws using a Phillips screwdriver. Turn both screws several times before tightening them completely to allow the module to sit correctly.

Installing an SRP Module

To install an SRP module:

1.Ground yourself by using an antistatic wrist strap or other device and connect it to the ESD grounding jack on the chassis.

NOTE: See the figures in “ERX Overview” on page 3 for module locations.

2.Choose the slot in which you want to install the module.

ERX-14xx models—Slot 6 or 7

ERX-7xx models—Slot 0 or 1

ERX-310 router—Slot 0

42 Installing SRP I/O and SRP Modules