Juniper Networks 8 ERX-310 Router (AC Model)

Cabling ERX Routers
Figure 27: ERX-310 Router, Rear View (DC Model)
Ground Power B
switch
DC power
input B
DC power
input A
Power A
leads
POWER B POWER A
-48VDC RTN
ON
|
O
OFF
-48VDC RTN
ON
|
O
OFF
Power A
switch
g013753
ERX-310 Router (AC Model)
1. Insert the power cordinto the AC power IEC receptacle. (See Figure 28.)
2. Insert the other end of the powercord into an appropriate AC power source.
NOTE: Toprovide redundancy, do not terminate PowerA and Power B leads at the
same power source.
3. Repeat Steps 1–2 for the other power input module, if needed.
Figure 28: ERX-310 Router, Rear View (AC model)
Ground
AC power input A
with switch
AC power input B
with switch
POWER A POWER B
100-240V ~ 5A
50/60 Hz
|
O
|
O
g013754
Cabling the Router for Power 65