Juniper Networks 8 manual SRP I/O Module Serial Port

ERX 8.0.x Hardware Guide

Figure 52: SRP I/O Module Serial Port

10/100

BASE T

PIN 1

RS-232

PIN 9

DB-9 g013771

Table 19 lists the pinout for the serial cable’s RS-232 connector.

Table 19: SRP I/O Module—RS-232 Serial Connector Pinout

Pin	Signal
1	DCD
2	RXD
3	TXD
4	DTR
5	GND
6	DSR
7	RTS
8	CTS
9	RNG

After you have configured an IP address on the system, you can connect using a host running Telnet over the 10/100Base-T Ethernet port on the SRP I/O module. The router ships with a straight-through cable having a male RJ-45 Ethernet connector on each end. Figure 53 shows the location of the Ethernet port and the sequence of the pins in the RJ-45 connector.

144 SRP I/O Module