Juniper Networks 8 manual Ejectors in the Open Position

Installing Modules

3.With a Phillips screwdriver, loosen the captive screws that secure the blank filler panel covering the empty chassis slot, if present, and remove the filler panel.

4.Remove the SRP module from its antistatic bag, being careful not to touch module components, pins, leads, or solder connections.

5.Verify that the ejectors are in the open position, as shown in Figure 20.

Figure 20: Ejectors in the Open Position

Œ

Opened

•

Closed

•

Closed

Œ	g013746
Opened

6.Slide the module into the chassis by placing it between the guides of the selected slot and pushing the module until it stops.

The module stops sliding when the ejectors make contact with the front of the chassis.

CAUTION: If you meet strong resistance when attempting to seat the module using the ejectors, remove it from the chassis and confirm that the slot is designed to hold the module. Then verify, if applicable, that the module matches its corresponding

Installing SRP I/O and SRP Modules 43