SATO GT 410, GT 424e, GT408 manual Printer Installation, Site Location, Cable Connection

Unit 3: Installation

PRINTER INSTALLATION

This chapter provides guidance on how to station, connect, and load the printer once unpacked. Following printer setup, procede to the next chapter for information on interface selection.

SITE LOCATION

•Stationed on a solid flat surface.

•Stationed away from hazardous materials.

•Stationed within operational distance of the host based on interface specifications.

CABLE CONNECTION

The procedure below provides instruction on typical cable connection. The same procedure will apply to others that are not mentioned, but their connectors are also located behind the rear housing cover.

1Press the rear housing ocver catch and remove laterally (Figure 3-2a).

2 Locate and identify the required connectors (Figure 3-2b).

3 Connect the power supply and interface cables to their respective connectors (Figure 3-2c). 4 Replace rear housing cover (Figure 3-2d).

Rear Housing Cover

Housing Cover Catch

Interface Connectors

Power Supply Connector

Figure 3-2a

Figure 3-2b

Pull Prevention Slot

Rear Housing Cover

Figure 3-2c

Figure 3-2d

SATO GT4xxe Series Operator Manual PN 9001138A Page 3-3