SATO GT 410, GT 424e, GT408 manual Advanced Mode

Unit 4: Operation

ADVANCED MODE

The Advanced Mode is provided to make basic printer operational adjustments. Typically, once these adjustments or settings have been made, they will not require additional address unless a new job is downloaded. The following table identifies the menus of the Advanced Mode and their purpose.

CANCEL + POWER
					HEAD CHECK
Printer					ENABLE	DISABLE
beeps							HEAD CHECK
	ENTER				Disable +	Enable +	NORMAL	BARCODE
					ENTER	ENTER
Press FUNCTION	DARKNESS RANGE
anytime to return to	A B C D	E	F		EXTERNAL SIGNAL
Advanced Mode.
	CANCEL		ENTER		ENABLE	DISABLE
							EXTERNAL SIGNAL
					CANCEL
	PRINTER TYPE						TYPE1	TYPE2
					Disable +	Enable +	TYPE3	TYPE4
	AUTO SETTING				ENTER	ENTER
	YES	NO
	ENTER		CANCEL		EXTERNAL REPRINT
					ENABLE	DISABLE
Only	PRINTER TYPE
visible when hardware	CONTINUOUS				ENTER	CANCEL
is installed and
	TEAR OFF
detected by the
	DISPENSER
printer.					AUTO ONLINE
	CUTTER
	LINERLESS				YES	NO
	CANCEL		ENTER
					CANCEL	ENTER
Only	BACKFEED MOTION
visible if the Cutter,
					AUTO ONLINE FEED
Dispenser and or	AFTER
Linerless features are
	BEFOR				YES	NO
selected. Only BEFOR or
	NONE
NONE can be selected
for Linerless	ENTER		CANCEL		ENTER	CANCEL
feature.
	REWINDER				FEED ON ERROR
Only	ON	OFF			YES	NO
visible if the
Dispenser feature has	CANCEL		ENTER		CANCEL	ENTER
been selected and the
Continuous print
operation mode	PRINT METHOD				PROTOCOL CODE
is active.
	TRANSFER	DIRECT			STANDARD
					NON-STANDARD
ENTER	ENTER		CANCEL		ENTER	CANCEL
SENSOR TYPE	PITCH SENSOR				SEMBL MODE		START PROGRAM
					AUTO START
	ENABLE DISABLE
I-MARK1					YES	NO	OWN_PROG.BAS
GAP
							SAMPLE_1.BAS
I-MARK2
	Enable/Disable			ENTER	No / Yes		ENTER
					ENTER

Figure 4-3, Advanced Mode

SATO GT4xxe Series Operator Manual PN 9001138A Page 4-4