SATO GT 410 INTERFACE MODES 4-4 THROUGH, Menu, Description, 4800, 19200, Parity Bit, Protocol

Unit 4: Operation

			INTERFACE MODES (4-4 THROUGH 4-8)
MENU				DESCRIPTION
				Allows determination of which method of configuration has
				priority; the relative dip switch or the LCD menu. This screen is
RS-232C/422/485
				displayed only when the applicable interface card is installed.
CONFIGURATION
DIPSW		LCD
				Allows selection of the baud rate. Will only appear when the
				RS232C interface is installed and the LCD option is chosen
BAUDRATE
				from the prior menu.
2400		4800
9600	19200
				Allows setting of the Parity Bit for the RS232C interface. Will not
				display if the dip switch priority option is chosen. The interface
				card must be installed.
PARITY BIT
NONE ODD EVEN
				Allows Stop Bit selection for the RS232C interface. Will not
				display if the dip switch priority option is chosen.
STOP BIT
1BIT		2BIT
				Allows selection of the data length for the RS232C interface.
				Will not display if the dip switch priority option is chosen.
CHARACTER BIT
7BIT		8BIT
				Allows setting of communication protocol. Will only appear if
				RS232C or RS422/485 interface is installed (except if the
PROTOCOL				relative dip switch is set with either as the priority).
READY/BUSY
XON/OFF
STATUS2
STATUS3
STATUS4
STATUS5
MULTIDROP
				Allows setting for output timing of ACK signal for Centronics
				interface. Select ON for output outside the busy signal and OFF
CENTRONICS				for inside the busy signal. Will only display if the Centronics
ACK SIGNAL				interface is installed.
ON		OFF

SATO GT4xxe Series Operator Manual PN 9001138A Page 4-31