SATO GT408, GT 424e, GT 410 manual INTERFACE MODES 4-4 THROUGH, Menu, Description

Unit 4: Operation

		INTERFACE MODES (4-4 THROUGH 4-8)
MENU			DESCRIPTION
			Allows BCC check to be enabled or disabled. Will only appear
			when Status5 is set for protocol.
BCC CHECK
ENABLE	DISABLE
			Allows selection of the receive buffer type. Select MULTI for
			multiple buffer and 1ITEM for a single item buffer. Will only
RECEIVE BUFFER			appear if RS232C, RS422/485, IEEE1284, or Centronics
MULTI	1ITEM		interface is installed unless the card is set for RS232C, RS422/
			485, or Centronics is set for protocol.
			Allows setting for ACK width of IEEE1284 interface. Display will
			appear when the IEEE1284 interface is present and one item is
IEEE1284			selected as a receive buffer.
ACK SIGNAL
	00.5 µs
			Determines whether the print data code requires deletion.
			Hexadecimal graphic data will not be deleted. Select YES to
IGNORE CR/LF			delete all carriage return (CR) and line feed (LF) commands in
YES	NO		the data stream including graphics and 2D bar codes.
			This feature is used primarily to maintain compatibility with
			earlier models of SATO printers.
			Allows 1 byte command such as CAN and DLE code to be
			deleted. Will only appear when the communication protocol is
IGNORE CAN/DLE			STATUS4 (for overseas precifications).
YES	NO
			Allows select of the port to receive print data. CARD1 will
			receive data sent from the exsting interface and CARD2 will
DATA PORT			receive print data from the Mini LAN. When print data is
CARD1	CARD2		received from a port different from the specified setting, the data
			will be dleted.
			Use this setting to enable or disable the status return port. The
			interface card which is not being used as the data input port is
STATUS PORT
			the status return port. This selection should be relative to the
ENABLE	DISABLE		setting of the prior menu.

SATO GT4xxe Series Operator Manual PN 9001138A Page 4-30