NETGEAR FVS318N Type TunnelModeConfig, VPN client advanced authentication settings Mode Config

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

7.Specify the settings that are explained in the following table.

Table 60. VPN client advanced authentication settings (Mode Config)

Setting	Description
Advanced features
Mode Config	Select this check box to enable Mode Config.
Aggressive Mode	Select this check box to enable aggressive mode as the mode of negotiation with
	the wireless VPN firewall.
NAT-T	Select Automatic from the drop-down list to enable the VPN client and wireless
	VPN firewall to negotiate NAT-T.
Local and Remote ID
Local ID	As the type of ID, select DNS from the Local ID drop-down list because you
	specified FQDN in the wireless VPN firewall configuration.
	As the value of the ID, enter client.com as the local ID for the VPN client.
	Note: The remote ID on the wireless VPN firewall is the local ID on the VPN
	client.
Remote ID	As the type of ID, select DNS from the Remote ID drop-down list because you
	specified an FQDN in the wireless VPN firewall configuration.
	As the value of the ID, enter router.com as the remote ID for the wireless VPN
	firewall.
	Note: The local ID on the wireless VPN firewall is the remote ID on the VPN
	client.

8.Click Apply to use the new settings immediately, and click Save to keep the settings for future use.

Create the Mode Config IPSec Configuration (Phase 2 Settings)

Note: On the wireless VPN firewall, the IPSec configuration (phase 2 settings) is referred to as the IKE settings.

To create an IPSec configuration:

1.In the tree list pane of the Configuration Panel screen, right-click the GW_ModeConfig authentication phase name, and then select New Phase 2.

2.Change the name of the IPSec configuration (the default is Tunnel):

a.Right-click the IPSec configuration name.

b.Select Rename.

c.Type Tunnel_ModeConfig.

d.Click anywhere in the tree list pane.

Virtual Private Networking Using IPSec and L2TP Connections

255