NETGEAR FVS318N manual VPN client IPSec configuration settings Mode Config, 256, 192.168.1.1

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

Note: This is the name for the IPSec configuration that is used only for the VPN client, not during IPSec negotiation. You can view and change this name in the tree list pane. This name needs to be a unique name.

The IPSec pane displays in the Configuration Panel screen, with the IPSec tab selected by default:

Figure 152.

3.Specify the settings that are explained in the following table.

Table 61. VPN client IPSec configuration settings (Mode Config)

Setting	Description
VPN Client	This field is masked out because Mode Config is selected. After an IPSec connection is
address	established, the IP address that is issued by the wireless VPN firewall displays in this field
	(see Figure 157 on page 260).
Address Type	Select Subnet address from the drop-down list.
Remote host	The address that you need to enter depends on whether you have specified a LAN IP
address	network address in the Local IP Address field on the Add Mode Config Record screen of
	the wireless VPN firewall:
	• If you left the Local IP Address field blank, enter the wireless VPN firewall’s default LAN
	IP address as the remote host address that opens the VPN tunnel. For example, enter
	192.168.1.1.
	• If you specified a LAN IP network address in the Local IP Address field, enter the
	address that you specified as the remote host address that opens the VPN tunnel.

Virtual Private Networking Using IPSec and L2TP Connections

256