NETGEAR FVS318N manual Configure a PPPoE IPv6 Internet Connection

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

5.Click Apply to save your changes.

6.To verify the connection, click the Status option arrow in the upper right of the screen to display the Connection Status pop-up screen. (The following figure shows a static IP address configuration; the IP addresses are not related to any other examples in this manual.)

Figure 22.

The Connection Status screen should show a valid IP address and gateway, and you are connected to the Internet. If the configuration was not successful, see Troubleshoot the

ISP Connection on page 382.

Note: For more information about the Connection Status screen, see View

the WAN Port Status on page 367.

Note: If your ISP requires MAC authentication and another MAC address has been previously registered with your ISP, then you need to enter that address on the Broadband Advanced Options screen for the corresponding WAN interface (see Configure Advanced WAN

Options and Other Tasks on page 50).

Configure a PPPoE IPv6 Internet Connection

To configure a PPPoE IPv6 Internet connection, you need to enter the PPPoE IPv6 information that you should have received from your ISP.

To configure PPPoE IPv6 broadband ISP settings:

1.Select Network Configuration > WAN Settings > Broadband ISP Settings.

2.In the upper right of the screen, select the IPv6 radio button. The ISP Broadband Settings screen displays the IPv6 settings:

IPv4 and IPv6 Internet and Broadband Settings

43