Virtual Private Networking Using IPSec and L2TP Connections
254
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
4. Specify the settings that are explained in the following table.
5. Click Apply to use the new settings immediately, and click Save to keep the settings for
future use.
6. Click the Advanced tab in the Authentication pane. The Advanced pane di s pl a ys :
Figure 151.
Table 59. VPN client authentication settings (Mode Config)
Setting Description
Interface Select Any from the drop-down list.
Remote Gateway Enter the remote IP address or DNS name of the wireless VPN firewall. For example,
enter 192.168.15.175.
Preshared Key Select the Preshared Key radio button. Enter the pre-shared key that you already
specified on the wireless VPN firewall. For example, enter H8!spsf3#JYK2!. Confirm
the key in the Confirm field.
IKE Encryption Select the 3DES encryption algorithm from the drop-down list.
Authentication Select the SHA1 authentication algorithm from the drop-down list.
Key Group Select the DH2 (1024) key group from the drop-down list.
Note: On the wireless VPN firewall, this key group is referred to as
Diffie-Hellman Group 2 (1024 bit).