NETGEAR FVS318N Add Vlan Profile screen settings, Setting Description Vlan Profile, IP Setup

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

3.Enter the settings as explained in the following table:

Table 11. Add VLAN Profile screen settings

Setting	Description
VLAN Profile
Profile Name	Enter a unique name for the VLAN profile.
VLAN ID	Enter a unique ID number for the VLAN profile. No two VLANs can have the same
	VLAN ID number.
	Note: You can enter VLAN IDs from 2 to 4089. VLAN ID 1 is reserved for the
	default VLAN; VLAN ID 4094 is reserved for the DMZ interface.
Port Membership
Port 1, Port 2, Port 3,	Select one, several, or all port check boxes to make the ports members of this
Port 4, Port 5, Port 6,	VLAN.
Port 7, and	Note: A port that is defined as a member of a VLAN profile can send and receive
Port 8 / DMZ
	data frames that are tagged with the VLAN ID.
IP Setup
IP Address	Enter the IP address of the wireless VPN firewall (the factory default address is
	192.168.1.1).
	Note: Always make sure that the LAN port IP address and DMZ port IP address
	are in different subnets.
	Note: If you change the LAN IP address of the VLAN while being connected
	through the browser to the VLAN, you are disconnected. You then need to open
	a new connection to the new IP address and log in again. For example, if you
	change the default IP address 192.168.1.1 to 10.0.0.1, you now need to enter
	https://10.0.0.1 in your browser to reconnect to the web management interface.
Subnet Mask	Enter the IP subnet mask. The subnet mask specifies the network number portion
	of an IP address. Based on the IP address that you assign, the wireless VPN
	firewall automatically calculates the subnet mask. Unless you are implementing
	subnetting, use 255.255.255.0 as the subnet mask (computed by the wireless
	VPN firewall).
DHCP
Disable DHCP Server	If another device on your network is the DHCP server for the VLAN, or if you will
	manually configure the network settings of all of your computers, select the
	Disable DHCP Server radio button to disable the DHCP server. Except for the
	default VLAN for which the DHCP server is enabled, this is the default setting.

LAN Configuration

61