NETGEAR FVS318N manual  To create an IPSec configuration, Type netgearplatform, 215

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

Table 48. VPN client advanced authentication settings (continued)

Setting	Description
Remote ID	As the type of ID, select DNS from the Remote ID drop-down list because you
	specified an FQDN in the wireless VPN firewall configuration.
	As the value of the ID, enter local.com as the remote ID for the wireless VPN
	firewall.
	Note: The local ID on the wireless VPN firewall is the remote ID on the VPN
	client. It might be less confusing to configure an FQDN such as router.com as the
	local ID on the wireless VPN firewall and then enter router.com as the remote ID
	on the VPN client.

8.Click Apply to use the new settings immediately, and click Save to keep the settings for future use.

Create the IPSec Configuration (Phase 2 Settings)

Note: On the wireless VPN firewall, the IPSec configuration (phase 2 settings) is referred to as the IKE settings.

To create an IPSec configuration:

1.In the tree list pane of the Configuration Panel screen, right-click the vpn_client authentication phase name, and then select New Phase 2.

2.Change the name of the IPSec configuration (the default is Tunnel):

a.Right-click the IPSec configuration name.

b.Select Rename.

c.Type netgear_platform.

d.Click anywhere in the tree list pane.

Note: This is the name for the IPSec configuration that is used only for the VPN client, not during IPSec negotiation. You can view and change this name in the tree list pane. This name needs to be a unique name.

The IPSec pane displays in the Configuration Panel screen, with the IPSec tab selected by default:

Virtual Private Networking Using IPSec and L2TP Connections

215