NETGEAR FVS318N manual VPN client IPSec configuration settings, 216, Esp

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

Figure 129.

3.Specify the settings that are explained in the following table.

Table 49. VPN client IPSec configuration settings

Setting	Description
VPN Client address	Either enter 0.0.0.0 as the IP address, or enter a virtual IP address that is used by
	the VPN client in the wireless VPN firewall’s LAN; the computer (for which the VPN
	client opened a tunnel) appears in the LAN with this IP address.
Address Type	Select Subnet address from the drop-down list. This selection defines which
	addresses the VPN client can communicate with after the VPN tunnel is
	established.
Remote LAN address	Enter 192.168.1.0 as the remote IP address (that is, LAN network address) of the
	gateway that opens the VPN tunnel.
Subnet mask	Enter 255.255.255.0 as the remote subnet mask of the gateway that opens the VPN
	tunnel.
ESP	Encryption	Select 3DES as the encryption algorithm from the drop-down list.
	Authentication	Select SHA-1as the authentication algorithm from the drop-down
		list.
	Mode	Select Tunnel as the encapsulation mode from the drop-down list.

Virtual Private Networking Using IPSec and L2TP Connections

216