Manage Users, Authentication, and VPN Certificates
308
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
4. In the Defined Addresses Status section of the screen, select one of the following radio
buttons:
•Deny Login from Defined Addresses. Deny logging in from the IP addresses in the
Defined Addresses table.
•Allow Login only from Defined Addresses. Allow logging in from the IP addresses
in the Defined Addresses table.
5. Click Apply to save your settings.
6. In the Add Defined Addresses section of the screen, add an address to the Defined
Addresses table by entering the settings as explained in the following table:
7. Click the Add table button. The address is added to the Defined Addresses table.
8. Repeat Step 6 and Step 7 for any other addresses that you want to add to the Defined
Addresses table.
To delete one or more IPv4 addresses:
1. In the Defined Addresses table, select the check box to the left of each address that you
want to delete, or click the Select All table button to select all addresses.
2. Click the Delete table button.
Configure Login Restrictions Based on IPv6 Addresses
To restrict logging in based on IPv6 addresses:
1. Select Users > Users. The Users screen displays (see Figure 184 on page 304).
2. In the Action column of the List of Users table, click the Policies table button for the user for
which you want to set login policies. The policies submenu tabs display, with the Login
Policies screen in view.
3. Click the By Source IP Address submenu tab.
4. In the upper right of the screen, select the IPv6 radio butto n. The By Source IP Address
screen displays the IPv6 settings. (The following figure shows an IP address in the Defined
Addresses table as an example.)
Table 75. Defined addresses settings for IPv4
Setting Description
Source Address Type Select the type of address from the drop-down list:
• IP Address. A single IPv4 address.
• IP Network. A subnet of IPv4 addresses. You need to enter a netmask length in
the Mask Length field.
Network Address / IP
Address Depending on your selection from the Source Address Type drop-down list, enter
the IP address or the network address.
Mask Length For a network address, enter the netmask length (0–32).
Note: By default, a single IPv4 address is assigned a netmask length of 32.