ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

Table 61. VPN client IPSec configuration settings (Mode Config) (continued)

Setting

Description

 

 

 

Subnet mask

Enter 255.255.255.0 as the remote subnet mask of the wireless VPN firewall that opens

 

the VPN tunnel. This is the LAN IP subnet mask that you specified in the Local Subnet

 

Mask field on the Add Mode Config Record screen of the wireless VPN firewall. If you left

 

the Local Subnet Mask field blank, enter the wireless VPN firewall’s default IP subnet

 

mask.

 

ESP

Encryption

Select 3DES as the encryption algorithm from the drop-down list.

 

 

 

 

Authentication

Select SHA-1as the authentication algorithm from the drop-down list.

 

 

 

 

Mode

Select Tunnel as the encapsulation mode from the drop-down list.

 

 

 

PFS and Group

Select the PFS check box, and then select the DH2 (1024) key group from the drop-down

 

list.

 

Note: On the wireless VPN firewall, this key group is referred to as Diffie-Hellman

Group 2 (1024 bit).

4.Click Apply to use the new settings immediately, and click Save to keep the settings for future use.

Configure the Mode Config Global Parameters

To specify the global parameters:

1.Click Global Parameters in the left column of the Configuration Panel screen. The Global Parameters pane displays in the Configuration Panel screen:

Figure 153.

Virtual Private Networking Using IPSec and L2TP Connections

257

Page 257
Image 257
NETGEAR FVS318N manual Configure the Mode Config Global Parameters, 257