NETGEAR FVS318N manual Factory Default Settings, 390, Feature Login settings Default Behavior, Nat

A. Default Settings and Technical		A
	Specifications

This appendix provides the default settings and the physical and technical specifications of the wireless VPN firewall in the following sections:

•Factory Default Settings

•Physical and Technical Specifications

Factory Default Settings

You can use the factory default Reset button located on the rear panel to reset all settings to their factory defaults. This is called a hard reset (for more information, see Revert to Factory Default Settings on page 342):

•To perform a hard reset, press and hold the factory default Reset button for approximately 8 seconds (until the Test LED blinks rapidly). The wireless VPN firewall returns to the factory configuration settings that are shown in the following table.

•Pressing the factory default Reset button for a shorter period simply causes the wireless VPN firewall to reboot.

The following table shows the default configuration settings for the wireless VPN firewall:

Table 93. Wireless VPN firewall factory default configuration settings

Feature

Login settings

Default Behavior

User login URL	https://192.168.1.1
Administrator user name (case-sensitive)	admin
Administrator login password (case-sensitive)	password
Guest user name (case-sensitive)	guest
Guest login password (case-sensitive)	password

WAN settings

WAN IPv4 mode

WAN IPv6 mode

NAT

IPv4 only mode

390